期刊文献+

模块化数字逆变焊接系统的研究 被引量:2

Research on Separating Digital Inverter Welding System
下载PDF
导出
摘要 通过模块的组合,可实现手工电弧焊、点焊和碳弧气刨,TIG 氩弧焊,CO_2/MIG/MAG 焊等多种焊接功能,各个单元模块均是独立的微处理器控制系统,单元之间通过通信协议进行信息的传递,通过软件算法使逆变焊接电源单元具有多种外特性,满足了不同焊接工艺的要求。本文给出了系统硬件结构框图和软件流程,以及在强电磁干扰下的可靠性设计。 In this paper, the research of a kind of separating digital inverter system controlled by MCU based on 80C196KC is discusseG which eliminating the interference to the least and improve the expansibility of the system. Via module combination the system can achieve MMA, spot, carbon gauge, TIG, CO2/MIG/MAG welding purpose. Through flexible digital arithmetic, the welding system can generate the different feature curves to satisfied the different welding purpose. The scheme of system hardware and the diagram of software are given.
出处 《电气自动化》 北大核心 2007年第3期37-39,共3页 Electrical Automation
基金 本项目为科技部科研院所技术开发研究专项资金项目(项目编号:2002EG115040)
关键词 数字控制 逆变焊接系统 模块化 digital control inverter welding system separating unit
  • 相关文献

参考文献2

二级参考文献7

  • 1Karl J AstrOm 周兆英 等.计算机控制系统原理与设计[M].北京:电子工业出版社,2001..
  • 2Tzon Ying-yu et al.Fuzzy control of closed-loop regulated PWM inverter under large load variation[C].IEEE IECON,1993.
  • 3Jung Shilh-liang et al.Discrete sliding-mode control of a PWM inverter for sinusoidal output waveform synthesis with optimal sliding curve[J].IEEE Trans.on PE, 1996,11(4):567-576.
  • 4Jung Shilh-liang et al.Self-tuning discrete sliding mode control of a closed-loop regulated PWM inverter with optimal sliding surface[C].IEEE PESC, 1996.
  • 5Toshimasa et al.Waveform compensation of PWM inverter cyclic fluctuating loads[J].IEEE Trans.on IA, 1998,24(4):582-589
  • 6Tzou Ying-Yu et al.Adaptive repetitive control of PWM inverter for very low HD AC-voltage regulation with unknown loads[J].IEEE Trans.on PE, 1999,14(5):971-981.
  • 7Lin Bor-ren et al.Real-time digital control of PWM inverter with fuzzy logic compensator for nonlinear loads[C].IEEEIAS,1993.

共引文献88

同被引文献9

引证文献2

二级引证文献3

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部