期刊文献+

一种实用的开关电源EMI滤波器的设计方法 被引量:9

An EMI Filter Design Method for Switching Power Supplies
下载PDF
导出
摘要 根据CISPER EN550022标准提出了一种实用的开关电源EMI滤波器设计方法。它基于线上共模噪声和差模噪声原理,用一种特殊的分离器将电磁干扰噪声分离成共模噪声和差模噪声。传导发射是根据CISPEREN550022标准,通过线性阻抗稳定网络和接收机进行测试。通过分析噪声源的阻抗特性,确定了滤波器的结构。利用MathCAD进行仿真,根据CISPER EN550022标准实施实验,验证了该设计方法的可行性。 The paper presents a very practical EMI filter design method for switching power supplies according to ciSPER EN55022 STANDARD.The design method is based on the knowledge of base-line common mode and differential mode EMI.A special noise separator is used to separate the total conducted EMI noise into common mode and differential noise.Conducted emission tests are carried out conforming to CISPER EN55022 STANDARD,making use of LISN and receiver.Noise source's impedance characteristic was analyzed in order that EMI filter's makeup is fixed on.Simulation was carried out by means of MathCAD.The performance tests were carried out, according to CISPER EN55022 STANDARD,to verify the validity of the design method.
出处 《电力电子技术》 CSCD 北大核心 2007年第6期16-18,共3页 Power Electronics
关键词 滤波器 噪声/开关电源 filter noise/switching power supplies
  • 相关文献

参考文献4

  • 1Caponet M C,Profumo F,Tenconi A.EMI Filter Design for Power Electronics[A].IEEE PESC '02 Conf.Proc.[C].2002:2027~2032.
  • 2孟进,马伟明,张磊,赵治华.开关电源变换器传导干扰分析及建模方法[J].中国电机工程学报,2005,25(5):49-54. 被引量:66
  • 3Cadirci B Saka,Y Eristiren.Practical EMI-filter-design Procedure for High-power High-frequency SMPS According to MIL-STD 461[J].IEE Pro-Electr.Power Appl.,2005,7(4):775~782.
  • 4Schneider L M.Noise Source Equivalent Circuit Model for Off-line Converters and Its Use in Input Filter Design[A].IEEE Symp.Proc.'83[C].1983:167~175.

二级参考文献13

  • 1马伟明.电力电子系统中的电磁兼容[M].武汉水利电力大学出版社,1999..
  • 2Zhang W. Conducted EMI analysis of a boost PFC circuit[C]. In Proc.IEEE Applied Power Electron. Conf., Atlamta, Georgia, USA, 1997.
  • 3Zhu Huibin. Modeling-based examination of conducted EMI emissions from hard-and soft-switching PWM inverters[J]. IEEE Trans. Ind.Applicat., 2001, 37(5): 1383-1393.
  • 4Li Ran. Conducted electromagnetic emissions in induction motor drive systems part 1: time domain analysis and identification of dominant modes [J]. IEEETrans. Power Electron. , 1998, 13(4): 757-767.
  • 5Li Ran. Conducted electromagnetic emissions in induction motor drive systems part 2: frequency domain models [J]. IEEE Trans. Power Electron., 1998, 13(4): 768-776.
  • 6Christophe C J. A new metod for EMI study in boost derived PFC rectifiers [C]. Proc. PESC'99 Conf., Charleston, Sonth Carolina,USA, 1999.
  • 7Ran L. Measurement of conducted electro-magnetic emissions in PWM motor drives systems without the need for an LISN [J]. IEEE Trans. Electromag. Compat., 1999, 41(1): 50-55.
  • 8Zhang Dongbing. Non-intrinsic differential mode noise caused by ground current in an off-line power supply [C]. Proc. PESC'98 Conf., Fukuoku, Japam, 1998.
  • 9Qu S. Mixed-mode noise and its implications for filter design in offiine switching power supplies [J]. IEEE Trans. Power Electron.,2002, 17(4): 502-507.
  • 10Meng Jin, Ma Weiming. A new technique for modeling and analysis of mixed-mode conducted EMI noise[C]. In Proc. PESC'04 Conf.,Aachen, 2004, Germany.

共引文献65

同被引文献50

引证文献9

二级引证文献21

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部