摘要
GDX2包装机的CH补包器中最下方的储备烟包与模盒或烟包之间产生频繁摩擦,造成烟包外包的透明纸褶皱甚至磨破,当剔除产生的不合格烟包时,该透明纸磨损的烟包就会补入模盒进入下道工序,从而影响卷烟成品质量。为此,采用EASY412-DC-RPLC对GDX2包装机CH补包器进行了改进,通过PLC采集、移位不合格烟包的剔除信号,同时控制增设的气缸动作,使CH补包器中的烟包依靠气缸的动作补入模盒,从而避免了CH补包器中最下方烟包与模盒之间的摩擦,提高了卷烟成品的外观质量。
The frequent friction between the packet at the bottom of CH and the running packets or packet models resulted in its overwrapped film wrinkle or even worn out. Once defective packet was rejected, the film frazzled packet would be filled in the packet model and go through the following steps finally wrapped in a carton. The CH in GDX2 cigarette packing machine was improved with an EASY412-DC-R PLC. The reject signal was collected and shifted by the PLC, and an added cylinder was controlled to move the packet in CH into the packet model. The cigarette packet in CH maintained good appearance by avoiding the friction with packet models.
出处
《烟草科技》
EI
CAS
北大核心
2007年第6期26-28,共3页
Tobacco Science & Technology
关键词
GDX2包装机
PLC
CH补包器
气缸
GDX2 cigarette packing machine
PLC
Packet replacer CH
Cylinder
