期刊文献+

时效对Cu-3.2Ni-0.75Si-0.30Zn合金组织和性能的影响 被引量:5

Effect of aging on microstructure and properties of Cu-3.2Ni-0.75Si-0.3Zn alloy
下载PDF
导出
摘要 研究了时效温度和时效时间对Cu-3.2Ni-0.75Si-0.30Zn合金组织和性能的影响。结果表明,合金经900℃固溶,不同时间时效处理后,第二相呈弥散分布。合金经不同冷变形后时效,能获得较高的显微硬度与导电率,当时效温度达到500℃时,其显微硬度达到253.7Hv,导电率达到40%IACS。同时建立了该合金在500℃下,关于时效时间的一元导电率方程。时效前的预冷变形能够有力的促进合金在时效过程中第二相的析出,从而提高合金的显微硬度和导电率。 The effect of aging temperature and aging time on microstructure and properties of Cu-3.2Ni-0. 75Si- 0.30Zn alloy were studied. The secondary phase was dispersive distribution in the alloy after the alloy was solution at 900℃ and then aged at various time. The high hardness and electrical conductivity were obtained after various cold deformation and then aged at various time. The hardness and electrical conductivity reach 253.7Hv and 40%IACS respectively after the alloy aged at 500℃. The electrical conductivity equation were obtained after aging at 500℃. In order to obtain high hardness and high electrical conductivity,the cold rolling prior to the aging treatment was used to increase the precipitation rate.
出处 《功能材料》 EI CAS CSCD 北大核心 2007年第6期908-910,913,共4页 Journal of Functional Materials
基金 国家高技术研究发展计划(863计划)资助项目(2006AA03Z528) 国家自然科学基金资助项目(50571035) 河南省杰出青年基金资助项目(0521001200)
关键词 Cu-3.2Ni-0.75Si-0.30Zn合金 时效 冷变形 导电率方程 Cu-3.2Ni-0.7 5Si-0.3Zn alloy aging cold deformation electrical conductivity equation
  • 相关文献

参考文献9

二级参考文献20

  • 1赵冬梅,董企铭,刘平,金志浩,康布熙.高强高导铜合金合金化机理[J].中国有色金属学报,2001,11(z2):21-24. 被引量:124
  • 2藤原英道.-[J].日本金属学会志,1998,36(4):301-301.
  • 3Zhang Chenglian.船舶材料手册[M].北京:国防工业出版社,1989..
  • 4Cahn R W. Physical Metallurgy [ M]. Printed in the Netherlands, 1965. 581 - 583.
  • 5Tang N Y,Mater Sci Tech,1985年,1卷,270页
  • 6薛剑峰 张伯仁.IC引线框架材料的发展动向[J].仪表材料,1985,16(1):3-6.
  • 7有色金属及其热处理编写组.有色金属及其热处理[M].北京:国防工业出版社,1984.10.
  • 8盖伊AG 赫仑JJ.物理冶金学原理[M].北京:机械工业出版社,1981-04.271.
  • 9曹育文 马营生 唐祥云 等.中国铜合金引线框架材料的现状与发展[J].功能材料,1998,10:714-718.
  • 10Bi Keyun,Cao Shangtong.The Moden Electronic Package Technology[A].Bi Keyun,Yu Shouwen,Liu Sheng,et al.Proceedings of Third International Symposium On Electronics Packaging[C].Beijing:Tsinghua University Press,1998:2-5.

共引文献206

同被引文献50

  • 1黄金亮,叶权华,刘平,刘勇,田保红.用导电率研究Cu-Cr-Zr-Y合金的相变动力学[J].材料热处理学报,2006,27(2):132-136. 被引量:11
  • 2盖伊AG 赫仑JJ.物理冶金学原理[M].北京:机械工业出版社,1981-04.271.
  • 3Monzen R, Watanabe C. Microstructure and mechanical properties of Cu-Ni-Si alloys[ J]. Materials Science and Engineer A, 2008,483 -484:117 -119.
  • 4Rdzawski Z, Stobrawa J. Thermomechanical processing of Cu-Ni-Si-Cr-Mg alloy[J]. Materials Science and Technology, 1993, 9 (2) : 142 - 148.
  • 5Suzuki S, Shibutani N, Mimura K, et al. Improvement in strength and electrical conductivity of Cu-Ni-Si alloys by aging and cold rolling [J]. Journal of Alloys and Compounds, 2006, 417 : 116 - 120.
  • 6Huang F X, Ma J S, Ning H L, et al. Precipitation in Cu-Ni-Si-Zn alloy for lead frame[ J]. Materials Letters, 2003, 57:2135 -2139.
  • 7董琦棉.低浓度Cu-Ni-Si合金的组织及性能研究[D].长沙:中南大学,2010.
  • 8HUANG Fu-xiang, MA Ju-sheng, NING Hong-long, CAO Yun-wen, GENG Zhi-ting. Precipitation in Cu-Ni-Si-Zn alloy for lead frame[J]. Materials Letters, 2003, 57: 2135-2139.
  • 9SU Juan-hua, LI He-jun, DONG Qi-ming, LIU Ping, KANG Bu-xi. Prediction and analysis of the aging properties of rapidly solidified Cu-Cr-Sn-Zn alloy through neural network[J]. Journal of Materials Engineering and Performance, 2005, 14(3): 363-366.
  • 10SUN Z, LAITEM C, VINCENT A. Dynamic embrittlement at intermediate temperature in a Cu-Ni-Si alloy[J]. Materials Science and Engineering A, 2008, 447(1/2): 145-152.

引证文献5

二级引证文献44

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部