摘要
The influence of different technological parameter on material remove rate and surface quality of ZrO2 ceramics is studied using the cutting machining method of electroplate diamond wire saw with ultrasonic vibration.Experimental results show that,compared with the same experiment condition without ultrasonic vibration,this cutting method has the advantages of high material remove rate,good surface quality,little brokenness and so on.
The influence of different technological parameter on material remove rate and surface quality of ZrO2 ceramics is studied using the cutting machining method of electroplate diamond wire saw with ultrasonic vibration. Experimental results show that, compared with the same experiment condition without ultrasonic vibration, this cutting method has the advantages of high material remove rate, good surface quality, little brokenness and so on.
基金
Sponsored by Department of Education University Research Project of Liaoning Province(LN566)
关键词
制造工程
硬度
脆性
机械加工
超声波
manufacturing processes equipment
hard and brittle material
ultrasonic machining
diamond wire saw
sur-face quality
