摘要
论述了基于Pro/E与ADAMS的行星轮系的设计及动态仿真的方法和过程,论述了parasolid文件接口使用以及ADAMS齿轮副中啮合点创建方法,对仿真结果和理论计算结果进行了对比。
Based on Pro/E and ADAMS, this paper provided the methods and made a certain procedure of design and dynamic simulation of planet wheel system. Simultaneously ,the use of the interface file parasolid and the technique of setting up joggle point of gear pair in ADAMS have been discussed,the contrast of the result of simulation and the theoretic result has been offered in detail.
出处
《机械工程师》
2007年第7期58-59,共2页
Mechanical Engineer
基金
安徽省教育厅资助项目(kJ2007B274)
关键词
行星轮系
仿真
齿轮副
接口文件
planet wheel system
simulation
gear pair
interface file