基于WinCC的300MN模锻水压机监控系统设计

Design of 300 MN Die Forging Hydrostatic Press Monitoring and Controlling System based on WinCC

根据300MN模锻水压机控制系统具体情况和生产控制要求,采用拓扑网络结构,开发了基于西门子视窗控制中心(WinCC)的上位机监控系统,建立了上位机与PLC之间的数据通讯,完成了整个系统的状态监控、报警组态、数据管理等功能。使用测试表明,该系统界面友好,直观方便,各项控制功能及数据功能均达到或超过了设计要求。

The upper computer monitoring and controlling system based on SIMATIC WinCC is exploited according to the controlling system of 300MN die forging hydrostatic press and controlling needs, adopting topology network structure. It completes the date com- munication between upper computer and PLC, state monitory, alarm configuration, and the data management etc. The tests prove that the interface of the system is amicable and it is used intuitively and conveniently, All controlling and supporting functions reach or exceed the primary technical indices.