摘要
针对传统的斜楔模在同一制件上冲制有位置度要求的几个侧孔时的缺点,采用转动盘与斜面相结合的方式,在同一副模具上同时冲出有位置度要求的4个孔。
In terms of defects of the traditional oblique wedge die with several side holes that had position degree at the same product, method of integration with rotating wheel and slant was adopted. Four side holes that had position degree could be punched simultaneously by the same die.
出处
《模具技术》
2007年第5期15-16,94,共2页
Die and Mould Technology
关键词
侧孔
斜楔
转动盘
斜面
side hole
oblique wedge
rotating wheel
slant
