摘要
针对仿真转台控制系统的设备特点,设计了CAN总线硬件接口电路,分别编写了上位机和下位机CAN通信软件,并进行了实际应用实验.结果表明,设计完全正确,数据传输速率有较大提高.
In view of the characteristic of the control system for simulation turnplate, the hardware interface circuit for CAN bus was designed. The CAN communication softwares for the upper and lower computers were compiled, respectively. The practical application experiments were conducted, indicating that this design improves the data transmission rate substantially.
出处
《应用科技》
CAS
2007年第11期4-6,24,共4页
Applied Science and Technology
