摘要
运用D-H方法建立了QJ-6R焊接机器人运动学方程,并讨论了其运动学问题。在Matlab环境下,绘出了机器人工作空间;用Robotics Toolbox对该机器人进行了仿真建模,并对正、逆运动学进行了实例仿真。通过仿真,分析了机器人的运动情况,得到了机器人在不同坐标空间的各种运动参数曲线和数据,验证了连杆参数设计的合理性和运动算法的正确性,为机器人动力学、控制和规划的研究提供了可靠的依据。
The problem of the kinematics of QJ-6R welding robot was discussed based on the kinematics equation, which was built by D-H coordination system. The robot modeling and the forward, inverse kinematics examples were simulated with the Robotics Toolbox of Matlab program language, Based on the simulation, the motion of the robot was analyzed, the curvilinear figure and the data in different coordinate were obtained, The simulation proves that all the parameters are rational and the approach is right, also it is beneficial to the research of robot dynamics, control and planning
出处
《机电工程》
CAS
2007年第11期107-110,共4页
Journal of Mechanical & Electrical Engineering
