期刊文献+

有机硅改性丙烯酸酯乳液的制备及表征 被引量:7

Synthesis and characterization of silicone modified acrylate emulsion
下载PDF
导出
摘要 以γ-甲基丙烯酰氧丙基三甲氧基硅烷(KH-570)、八甲基环四硅氧烷(D4)、丙烯酸酯类单体为原料,制备了有机硅改性丙烯酸酯乳液。考察了乳化剂配比、有机硅用量对乳液及乳胶膜性能的影响,并用红外光谱、凝胶渗透色谱、透射电镜进行了表征。结果表明:KH-570先与低聚体D4开环预聚,再与丙烯酸酯类单体进行自由基聚合,可得到有机硅改性丙烯酸酯乳液;当有机硅占单体总质量的9%,其中m(KH-570)∶m(D4)=1∶9,m(MS-1)∶m(AEO)=2∶1时,乳液的黏度、凝胶率和乳胶膜的硬度随有机硅用量的增加而增大,乳胶膜的吸水率则降低;乳胶粒表面光滑均一,呈规则的圆球状,平均粒径为100 nm,其重均摩尔质量■=1.75×104g/mol,摩尔质量分布■/■=1.3。 The emulsion of silicone/acrylate polymer was prepared via the process of seeded emulsion polymerization.Firstly,the seeded emulsion of γ-methacryloxypropyltrimethoxysilane and octamethylcyclotetrasiloxane was obtained by ring-opening polymerization under acidic condition.Secondly,silicone modified acrylate polymer was successfully obtained by adding acrylate monomers to the seeded emulsion through free radical copolymerization The polymer was characterized by IR,GPC and electronic microscopy.Moreover,the effects of emulsifier ratio and the amount of silicone on the properties of emulsion and coating were investigated.The results confirmed that KH-570 monomer was first polymerized with D4 through ring-opening polymerization,and then polymerized with acrylate monomers through free-radical polymerization.When the mass ratio of MS-1 anionic surfactant and AEO nonionic surfactant was 1∶1~2∶1,the emulsion had low gel fraction,was creamy with sufficient blue light.As the amount of silicone increased,films formed from the emulsion had good adhesion and gel fraction,lower water absorptivity and increased hardness.The preferred mass fraction of silicone is about 9%.
出处 《有机硅材料》 CAS 2007年第6期318-320,共3页 Silicone Material
基金 陕西省教育厅产业化培育项目(04JC08)。
关键词 有机硅 丙烯酸酯 乳液聚合 γ-甲基丙烯酰氧丙基三甲氧基硅炕 silicone,acrylate,emulsion polymerization,γ-methacryloxypropyltrimethoxysilane
  • 相关文献

参考文献7

  • 1冯圣玉,张洁,李美江,等.有机硅高分子及应用[M].北京:化学工业出版社,2004.
  • 2DENG Xiaobo, CAO Shunsheng, LIU Bailing, et al. Preparation and surface properties of siloxane-acrylate copolymer with high siloxane content [J].Polym and Polym Compo, 2006, 14 (5) : 495- 502.
  • 3孙志娟,张心亚,黄洪,陈焕钦.有机硅氧烷改性丙烯酸酯乳液的合成研究[J].中国皮革,2006,35(1):41-45. 被引量:10
  • 4龙斌,黄春保,王海南,闵艳林.硅/丙复合乳液的制备方法及应用进展[J].纺织学报,2006,27(3):99-102. 被引量:11
  • 5BARADIE B, SHOICHET M S. Novel fluoro-terpolymers for coatings applications [J]. Macromolecules, 2005, 38:560- 5568.
  • 6GUO Tianying, CHEN Xi, Song Moudao, et al. Preparation and properties of core [poly (styrene-n- butyl acrylate)] shell [poly (styrene-methyl methacrylate-vinyl triethoxide silane)] structured latex particles with self-crosslinking characteristics [J]. J Appli Polym Sci, 2006, 100 (3): 1824-1830.
  • 7YANG Jun, ZHOU Shuxue, YOU Bo, et al. The preparation and surface properties of silicone-grafted acrylic copolymer coatings [J]. High Performance Polymers, 2005, 17 (1): 85-102.

二级参考文献37

  • 1黄光速,李克友.有机硅氧烷-丙烯酸酯共聚复合胶乳微相结构的研究[J].高分子材料科学与工程,1995,11(6):53-58. 被引量:31
  • 2范青华,黄英,刘香鸾.聚硅氧烷改性苯乙烯-丙烯酸丁酯共聚乳液膜性能的研究[J].合成橡胶工业,1995,18(5):276-278. 被引量:31
  • 3范青华,黄英,刘香鸾,张逊.核/壳型聚硅氧烷丙烯酸酯复合乳液的制备[J].应用化学,1995,12(3):52-56. 被引量:54
  • 4Hisaki T, Hiroharu O. A new resin system for super high solids coating [ J ].Progress in Organic Coatings , 1997,32 :197 - 203.
  • 5Bongioranni R. High performance UV-cured coatings for wood protection [J].Progress in Organic Coating, 2002, 4(45) :359- 363.
  • 6Chen M J, Chaves A, Osterholtz F D.Silianes in coatings technology [J]. Surface Coating International, 1996, 79(12):539- 545.
  • 7Larpent C, Tadros T F. Prepartion of microlatex dispersions using oil -in-water microemulsions [J]. Colloid Polymer Sci., 1991,269(11):1171 -1178.
  • 8Carsten H, Ivan C R. Influence of nonionic emulsifiers on the properties of vinyl acetate/VeoVa10 and vinyl acetate/ethylene emulsions raid paints[j ]. Progress in Organic Coatings, 1999,35:69- 77.
  • 9Opera S, Vald S, Staciu A. Epoxy urethane acrylate[ J ]. European Polymer Journal, 2000,36 : 373 - 378.
  • 10大森英三.功能性丙烯酸树脂[M].北京:化学工业出版社,1993..

共引文献22

同被引文献433

引证文献7

二级引证文献37

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部