摘要
在多模掺镱双包层光纤上,利用相位掩模法直接写制Bragg光栅作为激光器后腔镜,得到多波长激光输出.在室温下,通过调节偏振控制器可以得到稳定的单波长及多波长的激光输出,输出波长范围在1056~1061nm,线宽均小于0.02nm.在25W的976nm激光泵浦下,激光器得到功率为6W的多波长输出.
A switchable multi-wavelength double-clad fiber laser was demonstrated. Using a phase mask,the fiber Bragg gratings directly in a multimode double-clad Yb^3+-doped fiber were fabricated as the frequency selective mirror. The single-dual-triple- and four wavelengths output respectively through adjusting the polarization controller were obtained. The wavelength is between 1 056 nm to 1 060 nm and linewidth is less than 0.1 nm. Under a 25 W pump power of 976 nm laser, the maximum output power of the laser is above 6 W in multi-wavelength.
出处
《光子学报》
EI
CAS
CSCD
北大核心
2008年第2期209-211,共3页
Acta Photonica Sinica
基金
国家自然科学基金重点项目(60137010)资助
关键词
多波长可转换光纤激光器
双包层光纤
多模光纤光栅
偏振烧孔
Polarization Multi-wavelength switchable fiber laser
Multi-mode fiber grating
Double-clad fiber
hole burnin
(PHB)