期刊文献+

模糊自适应滑模控制器及其应用研究 被引量:1

Development and Application of an Adaptive Fuzzy Sliding-mode Controller
下载PDF
导出
摘要 针对传统滑模变结构控制器(SMC)的抖振现象,提出了一种模糊自适应滑模控制方法.该方法采用模糊逻辑系统来逼近传统SMC中不连续的控制信号,以削弱其由于不连续切换引起的抖振.另外,为了补偿实际应用中系统的不确定性,给出了相应的自适应算法,以调节模糊系统的参数,并给出了算法的Lyapunov稳定性证明.最后,通过对一个感应电机位置控制的数值仿真计算,验证了方法的有效性. In this paper, an adaptive fuzzy sliding-mode control strategy is presented, aiming at remedying the chattering phenomenon on conventional sliding-mode controller (SMC). A fuzzy logic system is utilized to approximate the discontinuous control signal, then the chattering phenomenon in classical SMC caused by discontinuous signal switching can be effectively alleviated. Moreover, an adaptive algorithm with a stability proof using Lyapunov theory is utilized to compensate for the uncertainties existed in practical systems, by adjusting the fuzzy parameters. Finally, a numerical simulation for position control in an induction motor is provided to demonstrate the effectiveness of the proposed approach.
出处 《德州学院学报》 2008年第2期53-56,共4页 Journal of Dezhou University
关键词 滑模控制 模糊自适应 抖振 sliding-mode control fuzzy adaptive control chattering
  • 相关文献

参考文献5

  • 1张昌凡,王耀南.基于智能协调控制的滑模系统[J].电子测量与仪器学报,2000,14(3):1-3. 被引量:10
  • 2Wai R J. Adaptive Sliding-mode Control for Induction Servo Motor Drive [C].//Proceedings IEE Electric Power Appl. Stevenage: IET,2000,147(6) : 553-562.
  • 3Wai R J. Fuzzy Sliding-mode Control Using Adaptive Tuning Technique [J]. IEEE Trans. on Electronics, 2007,54(1): 586-594.
  • 4Sadati N, Ghadami R. Adaptive Fuzzy Sliding Mode Control Using Multiple Models Approach[C]//2006 IEEE International Conference on Engineering of Intelligent Systems. New York: IEEE,2006: 1-6.
  • 5Wang L X. A course In Fuzzy Systems and Control[M]. New York: Prentice-Hall, 1997.

二级参考文献4

  • 1Zhang D Q,IEE Proccontrol Theory Appl,1999年,146卷,2期
  • 2Zhan Y J,IEEE Trans IE,1999年,46卷,2期
  • 3王耀南,计算智能信息处理技术及应用,1999年
  • 4高为炳,变结构控制理论基础,1990年

共引文献9

同被引文献5

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部