期刊文献+

DB685钢板表面裂纹缺陷原因分析

Analysis on cause to surface cracking of steel sheet DB685
下载PDF
导出
摘要 用金相显微镜和扫描电镜分析方法,对DB685钢板表面裂纹进行分析。结果表明,钢板表面裂纹的形成与稀土氧化物有关。由于钢中稀土氧化物偏析于原奥氏体晶界上,弱化了晶界,造成钢板在轧制过程中产生裂纹。 The surface cracks on steel sheet DB685 was analyzed by metallographic microscope and scanning electron microscope. The results show that the surface cracks on the steel sheets are caused primarily by insoluble rare-earth oxides, which segregate at the original austenite grain boundary leading to weakening of grain boundary and occurrence of the surface crack in rolling process.
出处 《武钢技术》 CAS 2007年第4期31-33,共3页 Wisco Technology
关键词 DB685钢板 裂纹 稀土氧化物 DB685 steel plate surface cracks rare-earth oxides
  • 引文网络
  • 相关文献

参考文献4

二级参考文献27

  • 1万恩同.稀土处理钢连铸结晶器保护渣的研制[J].钢铁研究,1993,21(5):8-11. 被引量:9
  • 2魏庆成,丁运乔,彭可雕.含BaO保护渣熔点及粘度的研究[J].重庆大学学报(自然科学版),1995,18(4):110-114. 被引量:8
  • 3王文科.全国保护渣技术研讨会论文集[M].,2001..
  • 4万恩同.94'包头国际稀土学术会议论文集[M].,1994.188-192.
  • 5万恩同.第五届稀土在钢中应用学术研讨会论文集[M].北京:中国稀土学会,1995..
  • 6余景生.稀土在钢中的应用[M].北京:冶金工业出版社,1987.56-57.
  • 7[3]Kyoden H, Doihara T, Nomura O. Development of Mold Pow-der for High Speed Continuous Casting of Steel [A]. Iron andSteel Society, eds. Mold Powder for Continuous Casting andBottom Pouring Teeming [C]. Pittsburgh: ISS,1987.45.
  • 8[4]Yamauchi A, Sorimachi K, Sakuraya T, et al. Heat Transferbetween Mold and Strand Through Mold Flux Film in Continu-ous Casting of Steel [J]. ISIJ International,1993,33(1):140-147.
  • 9[5]Jung Wook Cho, Hiroyuki Shibata. Effect of Solidification ofMold Fluxes on the Heat Transfer in Casting Mold [J]. Jour-nal of Non-Crystalline Solids,2001,282(3):110-117.
  • 10[6]Sakai H, Kawashima T. Crystallization Behavior of MoltenFluxes for High-Speed Continuous Casting of Middle-CarbonSteel [A]. Iron and Steel Society, eds. Proceedings of MoltenSlag, Fluxes and Salts [C]. Pittsburgh: ISS,1997.787-791.

共引文献28

;
使用帮助 返回顶部