摘要
传统计算和运用有限元计算是操纵系统现有的两种供强度校核用载荷计算方法,本文运用这两种方法对飞机操纵系统的典型段进行了计算,并比较了两种方法的具体计算结果,得出了相应的结论,扩展了计算供操纵系统强度校核用载荷的方法。
Both the traditional calculation and FEM technique are applied for the load computation on strength calibration of the control systems. In this paper, theses two methods are compared in the load calculation of the control system for a typical section of an aircraft and a corresponding conclusion is obtained through the comparison between the two results and therefore the load computation methods for strength calibration of the control systems have been expanded.
出处
《洪都科技》
2008年第1期1-6,共6页
Hongdu Science and Technology
关键词
操纵系统
载荷
坐标系转换
有限元
Control system Load Translation of coordinate system FEM
