摘要
分析了极图测量条件以及极图数据处理方法对所计算ODF质量的影响,对其原因做了讨论.结果表明,用1/4极图计算ODF存在着不合理之处,容易造成明显的误差,用测量全极图并做对称化处理的方法可显著地提高ODF的准确性,同时也可对不对称织构进行有效的定量分析.
The influence of measurement condition and calculation method of the polefigure on the quality of ODF analysis is studied and the reasons are discussed. Somedefects, which could result in obvious errors, are induced by the method of calculatingODF based on a quarter of the whole pole figure. It is suggested that the accuracy ofODF calculation can be increased by making the whole pole figure data average-weighted,and this method can also analyse the asymmetrical texture quantitatively and effectively.
出处
《北京科技大学学报》
EI
CAS
CSCD
北大核心
1997年第5期451-456,共6页
Journal of University of Science and Technology Beijing