摘要
介绍了在Z3050X16型摇臂钻床上一次装夹完成履带式推土机、挖掘机的驱动轮齿形加工及螺栓安装孔的加工工艺、工装设计以及夹具的结构形式、调整和操作方法，本文对分度机构的设计和工作原理及对刀机构的设计和调整都作了较详细的论述。
Processing technology and fixture design of Crowler Caterpillor bulldozer excavator's driving wheel teeth(Serrated form) and bolt mounting holes once on radial drilling machine type Z3050X16. Then fixture's structual stule adjusting and operating method were introduced.Secondly, the design and working principle of dividing mechanism and the design and regulntion of the training cutting tool mechanism were expouned.
出处
《延边大学农学学报》
1997年第3期176-181,共6页
Agricultural Science Journal of Yanbian University
关键词
摇臂钻床
夹具
调整对刀
齿形加工
驱动轮
Radial drilling machine
Fixture
Dividing location
Adjustiny device
Serratedform processing(regulale and train cutting tool)
