期刊文献+

筛网盘对聚α-甲基苯乙烯微球弹跳性能的影响 被引量:1

Influence of mesh pans on bounce properties of poly-olphe-methycstyrene microspheres
下载PDF
导出
摘要 介绍了利用筛网设计制作出的一种新型的反弹盘,并用于聚α-甲基苯乙烯(PAMS)微球的弹跳实验。分析了筛网盘与玻璃盘之间的差别和由此带来的对PAMS微球弹跳性能影响。通过实验分别研究了筛网盘相关的参数对微球表面粗糙度的影响。结果表明:采用筛网盘与玻璃盘相比,PAMS微球的弹跳性能的改善非常明显;筛网盘的使用较好地解决了在无等离子体的镀膜环境下(如热蒸发的方法制备PAMS微球表面聚酰亚胺涂层)PAMS微球的弹跳问题;为降低微球表面粗糙度,反弹盘应采用间歇振动的模式。 In this paper, mesh pans for coating poly-olphe-methycstyrene(PAMS) microspheres with polymer are designed. The difference between bounces on a mesh pan and a glass pan is evaluated. The capability of mesh pans for bouncing PAMS microspheres is examined. The effect of the related parameters of the mesh pans on the surface roughness of the microshells has been explored. The experimental results show that the mesh pans improve significantly the bounce of PAMS microspheres in comparison with glass pans. In order to improve the surface roughness of microspheres, an intermittent vibration mode must be applied on the mesh pans for bouncing the microsphere.
出处 《强激光与粒子束》 EI CAS CSCD 北大核心 2008年第7期1125-1128,共4页 High Power Laser and Particle Beams
基金 国家高技术发展计划项目
关键词 筛网盘 PAMS微球 弹跳性能 表面粗糙度 Mesh pans PAMS microsphere Bounce properties Surface roughness
  • 相关文献

参考文献6

  • 1Tabak M, Hammer J M, Glinsky M E, et al. Ignition and high gain with ultrapowerful lasers[J]. Phys Plasmas, 1994, 1:1626-1634.
  • 2Lindl J. Development of the indirect-drive approach to inertial confinement fusion and the target physics basis for ignition and gain[J].Phys Plasmas, 1995, 2(11): 3933-4023.
  • 3吴卫东,罗江山,张占文,黄勇.C_xH_(1-x)薄膜制备[J].原子能科学技术,1999,33(4):319-322. 被引量:9
  • 4Chen K C, Nikroo A. Improvement of surface smoothness of vapor-deposited polyimide coatings using a plastic mesh container as bounce pan [J]. Fusion Sci Technol , 2006,49: 721-727.
  • 5张占文,唐永建,李波,刘一杨,王朝阳,陈素芬,漆小波.旋转涂层法制备聚酰亚胺薄膜[J].强激光与粒子束,2006,18(7):1109-1112. 被引量:12
  • 6张继成,唐永建,吴卫东,黄勇.Cu_2O/C_(60)梯度薄膜的制备[J].强激光与粒子束,2001,13(5):587-590. 被引量:6

二级参考文献13

  • 1张占文,李波,唐永建,王朝阳,陈素芬,林波,初巧妹,黄燕华,黄丽珍,周兰,罗青.准动态柱腔充气靶制备工艺研究[J].强激光与粒子束,2005,17(2):209-212. 被引量:6
  • 2周丕璋.惯性约束聚变(ICF)的驱动源技术[J].核物理动态,1995,12(4):37-40. 被引量:2
  • 3唐永建.激光惯性约束聚变靶技术研究[J].核物理动态,1995,12(4):50-53. 被引量:35
  • 4郭成,朱维斗,金志浩.梯度功能材料的研究现状与展望[J].稀有金属材料与工程,1995,24(3):18-25. 被引量:30
  • 5Tsai F Y,Harding D R,Chen S H,et al.Effects of processing conditions on the quality and properties of vapor-deposited polyimide shells[J].Fusion Technology,2002:178-185.
  • 6Meyerhofer D.Characteristic of resist films produced by spinning[J].J Appl Phys,1978,49:3693.
  • 7Dylan E H,Jorge N Q,Stephen J P,et al.Effects of solvent evaporation rate on "skin" formation during spin coating of complex solutions[C]//Proc of SPIE.2000,3943:280-284.
  • 8Kauffman R L,Suter L J,Kornblum H N,et al.X-ray production in laser-heated Xe gas targets[R].UCRL-LR-105821-96-2,Lawrence Livermore National Laboratory,1996.
  • 9Ding R A,Wright W W.Preparation and fabrication of aromatic polyimides[J].J Appl Polymer,1967,11:609.
  • 10Emslie A G,Bonner F T,Pecr L G.Flow of a viscous liquid on a rotating disk[J].J Appl Phys,1958,29:858.

共引文献24

同被引文献11

引证文献1

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部