期刊文献+

Numerical simulation of flow around square cylinder using different low-Reynolds number turbulence models 被引量:3

Numerical simulation of flow around square cylinder using different low-Reynolds number turbulence models
下载PDF
导出
摘要 ABE-KONDOH-NAGANO,ABID,YANG-SHIH and LAUNDER-SHARMA low-Reynolds number turbulence models were applied to simulating unsteady turbulence flow around a square cylinder in different phases flow field and time-averaged unsteady flow field.Meanwhile,drag and lift coefficients of the four different low-Reynolds number turbulence models were analyzed.The simulated results of YANG-SHIH model are close to the large eddy simulation results and experimental results,and they are significantly better than those of ABE-KONDOH-NAGANO,ABID and LAUNDER-SHARMR models.The modification of the generation of turbulence kinetic energy is the key factor to a successful simulation for YANG-SHIH model,while the correction of the turbulence near the wall has minor influence on the simulation results.For ABE-KONDOH-NAGANO,ABID and LAUNDER-SHARMA models satisfactory simulation results cannot be obtained due to lack of the modification of the generation of turbulence kinetic energy.With the joint force of wall function and the turbulence models with the adoption of corrected swirl stream,flow around a square cylinder can be fully simulated with less grids by the near-wall. ABE-KONDOH-NAGANO, ABID, YANG-SHIH and LAUNDER-SHARMA low-Reynolds number turbulence models were applied to simulating unsteady turbulence flow around a square cylinder in different phases flow field and time-averaged unsteady flow field. Meanwhile, drag and lift coefficients of the four different low-Reynolds number turbulence models were analyzed. The simulated results of YANG-SHIH model are close to the large eddy simulation results and experimental results, and they are significantly better than those of ABE-KONDOH-NAGANO, ABID and LAUNDER-SHARMR models. The modification of the generation of turbulence kinetic energy is the key factor to a successful simulation for YANG-SHIH model, while the correction of the turbulence near the wall has minor influence on the simulation results. For ABE-KONDOH-NAGANO, ABID and LAUNDER-SHARMA models satisfactory simulation results cannot be obtained due to lack of the modification of the generation of turbulence kinetic energy. With the joint force of wall function and the turbulence models with the adoption of corrected swirl stream, flow around a square cylinder can be fully simulated with less grids by the near-wall.
出处 《Journal of Central South University of Technology》 EI 2008年第4期564-568,共5页 中南工业大学学报(英文版)
基金 Project(2006BAJ04B04)supported by the National Science and Technology Pillar Program in the Eleventh Five-year Plan Period Project(2006AA05Z229)supported by the National High Technology Research and Development Program of China Project supportedby the Scientific Research Foundation for the Returned Overseas Chinese Scholars,State Education Ministry Project(06wk3023)supported by Hunan Science and Technology Office
关键词 湍流模型 正方形 圆柱体 数字模拟 low-Reynolds number turbulence model flow around square cylinder numerical simulation
  • 相关文献

参考文献12

  • 1邓圭玲,段吉安,钟掘.双辊铸轧铸嘴内部铝液流动的三维数值仿真[J].中南大学学报(自然科学版),2005,36(4):615-620. 被引量:5
  • 2D. F. G. Dur?o,M. V. Heitor,J. C. F. Pereira.Measurements of turbulent and periodic flows around a square cross-section cylinder[J].Experiments in Fluids.1988(5)
  • 3.
  • 4RODI W,FERZIGER J H,BREUER M,POURQUIE M.Status of large eddy simulation:Result of a workshop[].Journal of Fluid Mechanics.1997
  • 5IACCARINO G,OOI A,DURBIN P A,BEHNIA M.Reynolds averaged simulation of unsteady separated flow[].International Journal of Heat and Fluid Flow.2003
  • 6RODI W.Comparison of LES and RANS calculations of the flow around bluff bodies[].Journal of Wind Engineering and Industrial Aerodynamics.1997
  • 7LüBCKE H,SCHMIDT St,RUNG T,THIELE F.Comparison of LES and RANS in bluff-body flows[].Journal of Wind Engineering and Industrial Aerodynamics.2001
  • 8ABE K,KONDOH T,NAGANO Y.A new turbulence model for predicting fluid flow and heat transfer in separating and reattaching flows(II):Thermal field calculations[].International Journal of Heat and Mass Transfer.1995
  • 9YANG Z,SHIH T H.A k—εmodel for turbulent and transitional boundary layers[].Near Wall Turbulent Flows.1993
  • 10DUR-O D F G,HEITOR M V,PEREIRA J C F.Measurements of turbulent and periodic flows around a square cross-section cylinder[].Experiments in Fluids.1988

二级参考文献15

  • 1Hamer S, Smith D M, Yildizbayarak G, et al. Twin roll casting of aluminum at 2.5 mm gauge: production and process improvement[A]. Light Metals 1999[C]. Warren Dale: TMS, 1999:931-937.
  • 2Beals R, Duvuri R, Hamer S, et al. Recent innovations in advanced casting technology[A]. Light Metals 1998 [C]. Warren Dale: TMS, 1998:1161 -1167.
  • 3Menet P Y, Hoffinmana J L, Maiwald K. Development of sheet for canstock and other applications on pechiney neuf-brisac 3CMTM caster [A]. Light Metals 1998[C]. Warren Dale: TMS, 1998:1153-1160.
  • 4Daland O, Espedal A B, Nedreberg M L, et al. Thin gauge twin-roll casting process capabilities and quality[A]. Light Metals 1997[C]. Warren Dale: TMS,1997:745 - 752.
  • 5Menet P Y, Cayol R, Moriceau J, etal. PECHINEY JUMBO 3CM^TM start-up of the NEUF-BRISACH thinstrip caster [A]. Light Metals 1997 [C]. Warren Dale: TMS, 1997:753- 756.
  • 6Cortes M. PECHINEY JUMBO 3CM^TM : the new demands of thin strip casting [A]. Light Metals 1995[C]. Warren Dale : TMS, 1995:1161-1164.
  • 7Sarioglu K, Yildizbayrak G, Dundar M. Computer simulation of metal feeding used in twin roll casting[A]. Light Metals 2000[C]. Warren Dale, TMS,2000,663 - 666.
  • 8Yu H, Ai D K. Roll caster apparatus having converging tip assembly [P]. US4526223. 1985 - 06 - 02.
  • 9Yu H, Ai D K. A fluid mechanics consideration of the rolling caster tip design criteria [A]. Light Metals 1986 [C]. Warren Dale: TMS, 1986:897 - 908.
  • 10Smith D M. New system enables sheet width changes during casting [J]. Light Metal Ages, 2000, 57(8),130 - 133.

共引文献4

同被引文献19

  • 1严明,宿兴远,魏然,盛春华.应用改进的低雷诺数湍流模型预测转捩流动[J].航空动力学报,2009,24(12):2683-2688. 被引量:6
  • 2郭良斌,王祖温,包钢,李军.新型环面节流静压气体球轴承压力分布的有限元计算[J].摩擦学学报,2004,24(6):531-535. 被引量:22
  • 3郭良斌,包钢,王祖温,李军.环面节流静压气体球轴承承载力特性的实验研究[J].武汉大学学报(工学版),2005,38(4):68-70. 被引量:12
  • 4郭良斌,王祖温,孙昂.小孔节流静压气体球轴承的结构参数设计[J].哈尔滨工业大学学报,2005,37(11):1595-1598. 被引量:15
  • 5Asum K, Yoshiaki M, Heuy-Dong K. Shock train and pseudo-shock phenomena in internal gas flows[J]. Progress in Aerospace Sciences, 1999, 35: 33-100.
  • 6Liu Z S, Zhang G H, Xu H J. Performance analysis of rotating externally pressurized air bearings[J]. Journal of Engineering Tribology, 1999, 223(4): 653-663.
  • 7Coreu T L, Tyler C M, Rowand H H, et al. Behavior of air in the hydrostatic lubrication of loaded spherical bearings[J]. Trans of ASME, Journal of Basic Engineer, 1956, 78(7): 893-898.
  • 8John H L, Robert H N. Externally pressurized spherical gas bearings[J]. ASLE Trans, 1961, 4(1): 172-180.
  • 9Richard B, Daniel O. A new high speed mass properties instrument[C]//Proceedings of the 63rd Annual Conference of Allied Weight Engineers, Boston: SAWE Ine, 2004: 3341.
  • 10WANG Fusheng, BAO Gang. Research on a new type of center of mass measuring instruments[J]. Applied Mechanics and Materials, 2010, 29/30/31/32: 1722-1727.

引证文献3

二级引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部