期刊文献+

Effect of closed-couple gas atomization pressure on the performances of Al-20Sn-1Cu powders 被引量:1

Effect of closed-couple gas atomization pressure on the performances of Al-20Sn-1Cu powders
下载PDF
导出
摘要 Al-20Sn-1Cu powders were prepared by gas atomization in an argon atmosphere with atomizing pressures of 1.1 and 1.6 MPa. The characteristics of the powders are determined by means of dry sieving, scanning electron microscopy (SEM), optical microscopy (OM), and X-ray diffractometry (XRD). The results show that the powders exhibit a bimodal size distribution and a higher gas pressure results in a broad size distribution. All particles in both cases are spherical or nearly spherical and satellites form on the surface of coarse particles. Dendritic and cellular structures coexist in the particle. With decreasing particle diameter, the secondary dendrite arm spacing (SDAS) decreases and the cooling rate increases. The particles processed under high gas atomization pressure (1.6 MPa) exhibit a lower SDAS value and a higher cooling rate than those of the same size under low gas atomization pressure (1.1 MPa). The XRD results show that the Sn content increases with decreasing particle size. Al-20Sn-1Cu powders were prepared by gas atomization in an argon atmosphere with atomizing pressures of 1.1 and 1.6 MPa. The characteristics of the powders are determined by means of dry sieving, scanning electron microscopy (SEM), optical microscopy (OM), and X-ray diffractometry (XRD). The results show that the powders exhibit a bimodal size distribution and a higher gas pressure results in a broad size distribution. All particles in both cases are spherical or nearly spherical and satellites form on the surface of coarse particles. Dendritic and cellular structures coexist in the particle. With decreasing particle diameter, the secondary dendrite arm spacing (SDAS) decreases and the cooling rate increases. The particles processed under high gas atomization pressure (1.6 MPa) exhibit a lower SDAS value and a higher cooling rate than those of the same size under low gas atomization pressure (1.1 MPa). The XRD results show that the Sn content increases with decreasing particle size.
出处 《Rare Metals》 SCIE EI CAS CSCD 2008年第4期439-443,共5页 稀有金属(英文版)
基金 the Major State Ba-sic Research Development Program of China (Nos. 2006CB605203 and 2006CB605204)
关键词 powder production Al-Sn-Cu alloy gas atomization rapid solidification particle size distribution powder production Al-Sn-Cu alloy gas atomization rapid solidification particle size distribution
  • 相关文献

参考文献19

  • 1Ying J. and Anderson I.E., A computational fluid dynamics (CFD) investigation of the wake closure phenomenon, Mater. Sci. Eng. A, 2004, 379: 264.
  • 2Ting J., Michael W.E, and Eisen W.B., The effect of wake-closure phenomenon on gas atomization performance, Mater. Sci. Eng. ,4, 2002, 326: 110.
  • 3Unal R., The influence of the pressure formation at the tip of the melt delivery tube on tin powder size and gas/melt ratio in gas atomization method, J. Mater. Process. Technol., 2006, 180: 291.
  • 4Yule A.J. and Dunkley J.J., Atomization of Melts. for Powder Production and Spray Deposition, Oxford University Press, Oxford, 1994: 166.
  • 5Wolf G. and Bergmann H.W., Investigations on melt atomization with gas and liquefied, Mater. Sci. Eng. A, 2002, 326: 134.
  • 6Singh D.D. and Dangwal S., Effects of process parameters on surface morphology of metal powders produced by free fall gas atomization, J. Mater. Sci., 2006, 41: 3853.
  • 7Stefanescu D.M. and Ruxanda R., Fundamentals of Solidification, Metallography and Microstructures (ASM Handbook Vol 9), ASM International, OH, 2004:71.
  • 8Zambon A., Nitrogen versus helium: effects of the choice of the atomizing gas on the structures of Fe50Ni30Si10B10 and Fe32Ni36Ta7Si8B17 powders, Mater. Sci. Eng. A, 2004, 375- 377: 630.
  • 9Srivastava A.K., Ojha S.N., and Ranganathan S., Microstructural features associated with spray atomization and deposition of Al-Mn-Cr-Si alloy, J. Mater. Sci., 2001,36: 3335.
  • 10Juarez-islas J., Zhou Y., and Lavemia E.J., Spray atomization of two Al-Fe binary alloys: solidification and microstructure characterization, J. Mater. Sci., 1999, 34:1211.

同被引文献2

引证文献1

二级引证文献15

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部