期刊文献+

干湿空气对空压机功耗影响分析 被引量:13

Effect of Dry and Wet Air on Power Consumption of Air-Compressor
下载PDF
导出
摘要 通过建立理想的空压机模型,对压缩机进口分别采用干、湿空气时所消耗的功率进行了比较分析,研究结果表明:相同条件下湿空气功耗大于干空气,相对湿度越高,压缩能耗的浪费就越大。最后提出了除湿节能的基本措施。 The model of air-compressor was erected, and the power consumption of compressor inlet under the condition of dry air was compared with that of wet air. The result indicates that under the same condition, the consumption of wet air was more than that of dry air. In addition, the higher the relative humidity, the greater the waste of compressed energy consumption. Furthermore, the basic measures were put forward for removing humid and saving energy.
机构地区 中原工学院
出处 《建筑节能》 CAS 2008年第9期23-24,共2页 BUILDING ENERGY EFFICIENCY
关键词 干、湿空气 空压机 功耗 除湿 dry and wet air air-compressor power consumption removing humid
  • 相关文献

参考文献4

二级参考文献18

  • 1熊伟,冯全科.螺杆压缩机研究现状与热点[J].流体机械,2005,33(3):30-33. 被引量:31
  • 2三吉清忠[日].螺杆压缩机转子的热膨胀[J].流体工程,1987,(9).
  • 3邓定国 束鹏程.回转压缩机[M].北京:机械工业出版社,1991.14-37.
  • 4Stosic N, Hanjalic K, General Method for Screw Compressor Profile Generation[ A ]. Wemer Soedel. Proceedings of the 1996 International Compressor Engineering Conference at Purdue[ C]. West Lafayette: Purdue University, 1996.157-162.
  • 5Dmytro Zaytsev, Carlos A. Infante Ferreim, Screw Compressor Rotors Profile Generation Method Based on Pre-Defined Meshing Line [A]. YU Yongzhang , ed. Proceedings of the 3^nd International Compressor Technique Conference[C]. Xi'an: Xi'an Jiaotong University Press, 2001, 117-127.
  • 6Jack Sauls. Development of a Comprehensive Thermodynamic Modeling System for Refrigerant Screw Compressors[A]. Wemer Soedel. Proceedings of the 1996 International Compressor Engineering Conference at Purdue[C].West Lafayette: Purdue University, 1996. 151-156.
  • 7Fong Z K, Huang F C, Fang H S. Evaluating the interlobe clearance of twin-screw compressor by the iso-clearance contour diagram (ICCD) [J]. Mechanism and Machine Theory,2001, 36 (6) : 725-742.
  • 8Stosic N,Smith Ian K, Kovacevic A. Rotor Interference in Screw Compressors [ A ]. YU Yongzhang, ed. Proceedings of the 3ra International Compressor Technique Conference[C]. Xi'an: Xi'an Jiaotong University Press,2001.134-142.
  • 9Stosic N, Mathematical Modelling of the Oil Influence upon the Working Cycle of Screw Compressol,s[A]. Wemer Soedel. Proceedings of the 1988 International Compressor Engineering Conference at Purdue[ C]. West lafayette:Purdue University, 1988. 354-361.
  • 10Holmes C S, Flexible Profile Grinding of Screw Compressor Rotors[ A] .Yongzhang YU, ed. Proceedings of the 3rd International Compressor Technique Conference[C].Xi'an: Xi'an Jiaotong university Press,2001.162-172.

共引文献41

同被引文献55

引证文献13

二级引证文献36

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部