摘要
利用X射线粉晶衍射法对金属板材及其磷化膜进行全谱和区段扫描,在确定镀膜中存在Zn2Fe(PO4)2.4H2O和Zn3(PO4)2.4H2O物相的基础上,求出Zn2Fe(PO4)2.4H2O的(100)和Zn3(PO4)2.4H2O的(020)衍射峰的计数强度,计算出样品磷化膜的磷比,从而判断出磷酸盐配比是否达到工艺要求。
Total and section spectra scanning for component analysis in the metal plates and their phosphide covering membranes were carried out using X-ray powder diffractometry. Based on the confirmation of existence of the chemical phases of Zn2Fe(PO4)2·4H2Oand Zn3 (PO4)2·4H2O,the intensities of the Zn2Fe (PO4)2·4H2O phase(100) and Zn3(PO4)2·4H2O phase (020) were obtained and phosphorous ratios in phosphide covering membranes of the samples were calculated for phosphate ratio control in the orocess flow of the covering membrane production.
出处
《岩矿测试》
CAS
CSCD
2008年第5期397-398,共2页
Rock and Mineral Analysis
基金
国土资源地质大调查项目资助--地质分析测试新方法研究(1212010816021)
关键词
X射线粉晶衍射法
磷及其化合物
磷比
X-ray powder diffractometry
phosphorus and its compounds
phosphorous ratio