摘要
The study of the thin bed responses and correction methods in cased hole density logging can provide a theoretical basis for research to improve data processing methods. By using the Monte Carlo program MCNP, the change of detector count from thin beds with the vertical depth was calculated at different casing thicknesses. The calculation showed that with the low density thin bed moving upward, detector count first increased to a maximum then decreased. The responses of a thin bed with a high density were opposite to those of a thin bed with a low density. The change curve was symmetrical, and the maximums or minimums appeared at the midpoint between the detector and source. Besides, detector count increased with increasing thin bed thickness. At a specific thin bed thickness, further increase of thin bed thickness resulted in a slow increase of detector count then the count rate leveled off. In actual logging, the influence of adjacent formations on density log measurements can be ignored. Finally, based on numerical simulation correction methods for the dual influence of casing and thin beds are discussed.
The study of the thin bed responses and correction methods in cased hole density logging can provide a theoretical basis for research to improve data processing methods. By using the Monte Carlo program MCNP, the change of detector count from thin beds with the vertical depth was calculated at different casing thicknesses. The calculation showed that with the low density thin bed moving upward, detector count first increased to a maximum then decreased. The responses of a thin bed with a high density were opposite to those of a thin bed with a low density. The change curve was symmetrical, and the maximums or minimums appeared at the midpoint between the detector and source. Besides, detector count increased with increasing thin bed thickness. At a specific thin bed thickness, further increase of thin bed thickness resulted in a slow increase of detector count then the count rate leveled off. In actual logging, the influence of adjacent formations on density log measurements can be ignored. Finally, based on numerical simulation correction methods for the dual influence of casing and thin beds are discussed.
