Evaluation of Energy Saving Operational Modes for Industrial Fracture Connected Processes on the Basis of Incubation Time Fracture Criterion

A problem for a central crack in a plate subjected to plane strain conditions is investi-gated. Mode Ⅰ crack loading is created by a dynamic pressure pulse applied at a large distance from the crack. It was found that for a certain combination of amplitude and duration of the pulse applied, the energy transmitted to the sample has a strongly marked minimum, meaning that with the pulse amplitude or duration moving away from the optimal values, minimum energy required for initiation of crack growth increases rapidly. The results obtained indicate a possibility to optimise energy consumption of different industrial processes connected with fracture. Much could be gained in, for example, drilling or rock pounding where energy input accounts for the largest part of the process cost. Presumably further investigation of the effect observed can make it possible to predict optimal energy saving parameters, i.e. frequency and amplitude of impacts, for industrial devices, e.g. bores, grinding machines, and hence significantly reduce the process cost. The pre-diction can be given based on the parameters of the media fractured (material parameters, preva-lent crack length and orientation, etc.).

A problem for a central crack in a plate subjected to plane strain conditions is investigated. Mode I crack loading is created by a dynamic pressure pulse applied at a large distance from the crack. It was found that for a certain combination of amplitude and duration of the pulse applied, the energy transmitted to the sample has a strongly marked minimum, meaning that with the pulse amplitude or duration moving away from the optimal values, minimum energy required for initiation of crack growth increases rapidly. The results obtained indicate a possibility to optimise energy consumption of different industrial processes connected with fracture. Much could be gained in, for example, drilling or rock pounding where energy input accounts for the largest part of the process cost. Presumably further investigation of the effect observed can make it possible to predict optimal energy saving parameters, i.e. frequency and amplitude of impacts, for industrial devices, e.g. bores, grinding machines, and hence significantly reduce the process cost. The pre- diction can be given based on the parameters of the media fractured （material parameters, prevalent crack length and orientation, etc.）.