摘要
提出了一种基于CAN总线的局域网设备状态检测的设计方案。该系统利用89S52单片机采集钢厂中硅钢的存在状态信息,然后将这些数据通过CAN总线传送给飞利浦32位ARM7处理器(芯片为LPC2292)进行处理,最后ARM处理器发送指令给单片机进行相应的动作。同时讨论了该方案的网络实现。
The design of networked loading detection system based on CAN has been come up with. This system gathers the state information of the steel in the steelworks with 89S52 MCS（single chip microcomputer）, and then transmits the information to the ARM7 processor with 32bits on the CAN bus. At last, the processor sends corresponding instruction to the MCS. Meanwhile, the realization of the network has been discussed in this paper.
出处
《微计算机信息》
北大核心
2008年第32期77-78,84,共3页
Control & Automation
关键词
CAN总线
ARM
单片机
数据采集
CAN（Control Area Network）bus
ARM
MCS（single chip microcomputer）
data acquisition
