摘要
原动仿真系统是电力系统动态模拟的重要设备,它对电力系统中的真实原动机(水轮机和汽轮机)及其调速器进行模拟。文中主要阐述了基于80C196KC单片机的原动仿真系统通信模块的硬件和软件设计,从硬件原理图的设计、芯片的选择,到软件的设计都进行了详细的说明,并用vB6.0和汇编语言进行了上位机和下位机的程序设计,在程序设计过程中,用状态转移图取代程序流程图对程序的部分设计过程进行了说明,对程序设计中应注意的问题进行了讨论。
The simulation system of prime mover is one of the most important parts in the power system dynamic simulation laboratory. It simulates the real prime mover （hydraulic turbine and steam turbine） and governor in power system. This paper mainly described the design of hardware and software based on 80C196KC in prime mover simulation system communication module, and conducted the detailed explanation of not only hardware schematic design and choice of chips but also the design of software, then gave a design with vB6.0 and Assemble language between PC an MCU, and explained the design process with the appearance transferred diagram replacing procedure flow one, finally discussed the noted question in programming.
出处
《仪表技术与传感器》
CSCD
北大核心
2009年第1期65-67,共3页
Instrument Technique and Sensor
基金
湖南省科技攻关项目(05GK3017)
湖南省自然科学基金项目(01JJY2106)
关键词
原动机仿真系统
通讯
程序设计
prime mover simulation system
communication
programming
