降低钢水氧含量工艺实践
摘要
针对100吨转炉钢水氧含量较高的现状,通过试验找出降低钢水终点氧含量的措施,从而达到提高钢水质量和降低炼钢成本的目的。
参考文献3
-
1赵长亮,孙彦辉,田志红,蔡开科,刘建华,成小军,吴光亮,周春泉.CSP热轧板卷边部裂纹成因[J].北京科技大学学报,2007,29(5):499-503. 被引量:9
-
2尹卫平,刘洪波,李洪春,孟凡玉.转炉钢水氧含量变化规律的研究[J].炼钢,2004,20(1):47-49. 被引量:12
-
3(德)F.奥特斯(FranzOeters)著,倪瑞明等译.钢冶金学[M]. 冶金工业出版社, 1997
二级参考文献9
-
1郑柏平.华菱涟钢CSP生产线情况介绍//薄板坯连铸连轧技术交流与开发协会第二次技术交流会论文集.包头,2004:73
-
2Maehara Y,Ohmori Y.Precipitation of AlN and NbC and the hot ductility of low carbon steels.Mater Sci Eng,1984,62(1):109
-
3Turkdogan E T.Causes and effects of nitride and carbonnitride precipitation in HSLA steels in relation to continuous casting//Steelmaking Conference Proceedings,ISS.Pittsburgh,1987,70:399
-
4Ryokichi S.Powder fluxes for ingot making and continuous casting.Steelmaking Conf AIME,1979,62:48
-
5Riboud P V,Larrecg M.Lubrication and heat transfer in a continuous casting mold.Steelmaking Conf AIME,1979,62:78
-
6Shinzo H,Shigenori T.A formation mechanism of transverse cracks on CC slab surface.ISIJ Int,1990,30(4):310
-
7Mohamed S,Claude E.Contribution of advanced microscopy techniques to nano-precipitates characterization:case of AlN precipitation in low-carbon steel.Acta Mater,2003,51:943
-
8Tsai H T,Yin H,Lowry M,et al.Analysis of transverse corner cracks on slabs and countermeasures//AIS Technol 2005 Proc.Vol Ⅱ.Charlotte,2005:201
-
9薛凌.薄板坯连铸连轧技术的进展[J].北京科技大学学报,2003,25(3):207-210. 被引量:7
共引文献19
-
1耿志军.转炉采用热补偿工艺提高终点命中率的研究[J].钢铁,2004,39(9):31-34. 被引量:8
-
2谢光远,陈华登,郭密,闫绍盟,李平生.钢水定氧中共沉淀法制备MgO-PSZ粉末的工艺优化[J].传感技术学报,2007,20(1):46-49. 被引量:2
-
3殷楷,付建军,李富峰.FTSC工艺生产热轧板卷的质量控制[J].天津冶金,2012(2):14-16. 被引量:5
-
4苑阳阳,张炯明,肖超,胡招凡,陈少东.49MnVS3非调质钢连铸方坯中心裂纹分析[J].北京科技大学学报,2012,34(8):892-897. 被引量:7
-
5刘国梁,倪有金,季晨曦,崔阳,陈瑾,包春林.J55热轧板卷边部裂纹成因及控制分析[J].钢铁,2012,47(10):61-65. 被引量:4
-
6高瑞,黄丽,孙朔.数据分析在转炉冶炼生产中的应用[J].钢铁技术,2018(4):40-43. 被引量:1
-
7曾四宝,张利武.提高60t转炉出钢口使用寿命的实践[J].山东冶金,2014,36(4):13-14. 被引量:1
-
8郑毅,胡建光,陈志平.150t转炉终点钢水锰含量分析及控制[J].炼钢,2014,30(5):9-13. 被引量:9
-
9岳重祥,吴圣杰,曹垒,李化龙.冷轧薄板边损边裂原因概述及实例分析[J].锻压技术,2014,39(11):107-112. 被引量:18
-
10王占国,郝占全,宋海武,殷楷,周士伟.FTSC中碳硼微合金钢热轧板卷边部裂纹分析[J].中国冶金,2015,25(7):17-23. 被引量:4
-
1M,CГ,周国忠.转炉钢水炉外精炼[J].国外钢铁,1994,19(8):33-35.
-
2周涛.转炉钢水氧活度,温度的测定及其变化规律的研究[J].浙江冶金,1993(4):9-17. 被引量:1
-
3李伯超,孙光,侯海龙,丁文胤.影响转炉钢水收得率因素分析[J].黑龙江冶金,2011,31(4):46-47. 被引量:2
-
4江涛勇.复吹转炉冶炼45钢的实践[J].炼钢,2004,20(6):18-20. 被引量:1
-
5张朝晖,巨建涛,李小明.转炉碳化硅脱氧试验研究[J].四川冶金,2001,23(1):13-14. 被引量:4
-
6张润宇,肖兵,张文弟.转炉钢水含碳量的估计[J].自动化学报,1993,19(3):381-383. 被引量:8
-
7李军辉,刘玲月.转炉LF精炼脱硫探讨[J].浙江冶金,2011(2):22-24. 被引量:1
-
8陶乃标,陈远清,梅凯,张少博,高辉,李亚波.LD→LF冶炼低碳钢钢水增碳行为研究[J].炼钢,2014,30(5):18-21. 被引量:3
-
9李硕,王振刚,刘善喜,张垚,张虎成.转炉冶炼焊条钢留渣操作实践[J].河南冶金,2016,24(1):23-25.
-
10陈亚平,袁志琳.EBT-LF-VD-CC工艺冶炼GCr15轴承钢氧含量的控制[J].广东科技,2012,21(7):152-153. 被引量:3