摘要
用MSC SuperForm软件对三层复合铝箔的轧制过程进行了有限元模型,得到了轧件的包覆板横向厚度分布特征。研究了压下量对横向厚度分布的影响,结果表明,通过改变压下量的大小,可以有效改善轧件的包覆板横向厚度分布不均的现象。
The model of the sandwiched aluminum sheets was built by finite element analysis software MSC SuperForm. From the simulation, the distribution of the thicknesses of the component layers was obtained in the traverse direction. The influence of the reduction on the thicknesses of the component layers was effectively improved by the change of reduction.
出处
《上海有色金属》
CAS
2009年第1期16-18,共3页
Shanghai Nonferrous Metals
关键词
复合铝箔
有限元模型
压下量
包覆板厚度
轧制
composite aluminum foil
finite element model
reduction
thicknesses of component layers
roiling
