期刊文献+

流体横掠圆形微针肋热沉流动与传热特性 被引量:9

FLOW AND HEAT TRANSFER CHARACTERISTICS ACROSS CIRCULAR-SHAPED MICRO PIN FIN HEAT SINKS
下载PDF
导出
摘要 本文以去离子水为冷却工质,对流体横掠当量直径为90~200μm的圆形微针肋阵列热沉的流动与传热特性进行了实验研究。实验数据显示:对于叉排实验件热沉,摩擦阻力系数对雷诺数的依变关系在Re=100前后发生转变;端壁效应、高径比和布置方式对摩擦阻力系数有很大影响;努塞尔特数随雷诺数的增大显著增大,其依变关系在双对数坐标下呈现较好的线性关系。 Flow and Heat Transfer Characteristics associated with the forced flow of de-ionized water over circular shaped micro pin-fin bundles with diameters ranging from 90 μm to 200 μm were experi- mentally investigated in the paper. To staggered micro pin-fin heat sinks, the variation of the friction factor with the Reynolds number shows a transition around Re=100. Density and arrangement of pin fins have strong effects on the friction factor. The experimental Nusselt number obviously increases with increasing Reynolds number, and their relation shows a good linear relation in double logarithm coordinate system.
出处 《工程热物理学报》 EI CAS CSCD 北大核心 2009年第4期621-624,共4页 Journal of Engineering Thermophysics
基金 国家自然科学基金项目(No.50876003) 北京市教育委员会科技计划重点项目(No.KZ200710005001) 北京市自然科学基金项目(No.3092009) 教育部博士点学科专项科研基金项目(No.20070005009)
关键词 微针肋 流动特性 传热特性数 micro pin fin flow characteristics heat transfer characteristics
  • 相关文献

参考文献4

  • 1Kosar A, Mishra C, Peles Y. Laminar Flow Across a Bank of Low Aspect Ratio Micro Pin Fin. Journal of Fluids Engineering, 2005, 127(3): 419-430.
  • 2Kosar A, Peles Y. Thermal-Hydraulic Performance of MEMS-Based Pin Fin Heat Sink. J. Heat Transfer, 2006, 128:121- 131.
  • 3Prasher R S, Dirner J, et al. Nusselt Number and Friction Factor of Staggered Arrays of Low Aspect Ratio Micropin-Fins Under Cross Flow for Water as Fluid. Journal of Heat Transfer, 2007, 129:141- 153.
  • 4夏国栋,李宴君,孔凡金.流体横掠方形微针肋阵列热沉的传热特性[J].工程热物理学报,2008,29(4):628-630. 被引量:9

二级参考文献4

  • 1Brignoni L A, Garimella V. Experimental Optimization of Confined Air Jet Impingement on a Pin Fin Heat Sink. IEEE Trans. Compon. Packag. Technol., 1999, 22(3): 399-404
  • 2Marques C, Kelly K W. Fabrication and Performance of a pin Fin Micro Heat Exchanger. Journal of Heat Transfer, 2004, 126:434-444
  • 3Peles Y, Kosar A, Mishra C, et al. Forced Convective Heat Transfer Across a Pin Fin Micro Heat Exchanger. Int. J. Heat Mass Transfer, 2005, 48:3615-3627
  • 4Kosar A, Peles Y. Thermal-Hydraulic Performance of MEMS-Based Pin Fin Heat Sink. J. Heat Transfer, 2006, 128:121-131

共引文献8

同被引文献81

  • 1B.Deng,T.T.Wong,W.Q.Tao.Forced Convective Heat Transfer and Pressure Drop of Air Flowing in a Rectangle Duct with Cross-Ribs on the Opposite Walls[J].Journal of Thermal Science,2002,11(3):259-270. 被引量:1
  • 2胡振军,神家锐.离散倾斜肋的传热强化及流动特性[J].工程热物理学报,1995,16(3):327-332. 被引量:6
  • 3朱恂,李刚,廖强,冯云鹏.水平三维肋管外含不凝性气体的水蒸汽凝结换热的实验研究[J].动力工程,2006,26(5):694-698. 被引量:4
  • 4Kosar A. Heat and Fluid Flow in MEMS-Based Pin Fin Heat Sinks [D]. Rensselaer Polytechnic Institute, Troy, 2006.
  • 5Triplett K A, Ghiaasiaan S M, Abdel K S. Two-Phase Flow in Mieroehannels Part II: Void Praction and Pressure Drop [J]. International Journal of Multiphase Flow, 1999, 25:395-410.
  • 6Lee J, Mudawar I. Two-Phase Flow in High Heat Flux Microchannel Heat Sink for Refrigeration Cooling Applications: Part I-Pressure Drop Characteristics [J]. International Journal of Heat Mass Transfer, 2005, 49:2446-2457.
  • 7Mishima K, Hibiki T. Some Characteristics of Air-water Flow in Small Diameter Vertical Rubes [J]. International Journal of Multiphase Flow, 1996, 22:703-712.
  • 8Zhang W. Study on Constitutive Equations for Flow Boiling in Mini-Channels [D]. Kyoto University, 2006.
  • 9Chisholm D. Pressure Gradients Due to Friction During the Flow of Evaporating Two-phase Mixtures in Smooth Tubes and Channels [J]. International Journal of Heat Mass Transfer, 1972, 16:347-348.
  • 10MARQUES C,KELLY K W.Fabrication and performanceof a pin fin micro heat exchanger[J].Journal of HeatTransfer,2004,126(3):434-444.

引证文献9

二级引证文献28

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部