摘要
由于校飞用合作目标载体的变化,导致原有监控系统不能适应,必须设计一套校飞控制系统来保障设备操控要求。对系统的软、硬件进行详细设计,在Proteus中进行硬件仿真,通过构建虚拟环境,进行软件级联测试,表明该系统设计完全满足校飞任务需求。
Because of the carrier change of the cooperation goal used for the calibration flying,a control system to meet the requirement of controlling equipments must be designed.This paper designs the hardware and software equipments.The hardware simulation is carried out based on the Proteus,and the software test is carried out by building a virtual environment.The results show that the designed system can meet the requirements of the calibration flying.
出处
《遥测遥控》
2011年第5期59-63,共5页
Journal of Telemetry,Tracking and Command
关键词
校飞
控制系统
MAPX
Calibration flying
Control system
MapX