剩余电流保护器的电磁兼容要求及试验方法——IEC61543-1995《家用和类似用途的剩余电流动作保护装置-电磁兼容性》标准介绍与分析

The Requirements and Testing Method of Electromagnetic Compatibility for Residual Current Operated Protective devices The Introduction and Analysis of IEC 61543 - 1995:Residual Current Operated Protective Devices for Household and Similar Use-lect

本文介绍IEC61543—1995《家用和类似用途的剩余电流动作保护器(RCD)—电磁兼容性》标准对剩余电流保护器电磁兼容(EMC)的要求。根据我国今年9月1日将实施的GBl6916.1等强制性国家标准的要求和目前欧共体颁布的89/336/EEC指令,剩余电流保护器必须经过EMC试验,对未经EMC试验或EMC性能不合格的产品,不能取得认证合格证书;既不能进入国内市场,也不得进入欧洲市场销售。提醒国内有关制造厂家注意,及早重视剩余电流保护器的EMC试验,并把EMC性能的要求列入产品企业标准。

This paper introduces the requirements of electromagnetic compatibility for residual current operated protective devices in IEC 61543 - 1995: Residual current operated protective devices (RCD)s for household and similar use - Electromagnetic compatibility. According to the requirements of mandatory national standards of GB16916.1 etc, which will become effective on September 1 of this year in our country, and the directive of 89/336/EEC issued by European Union at present, residual current operated protective devices must be submitted for EMS test. The products, which are not submitted for EMC test or EMC performance of which are not acceptable, could not acquire the Certificate of Conformity for Electrical Equipment and could not enter the Domestic market as well as European market for sale. This paper reminds the relative domestic manufacturers of paying attention to the EMC test of RCDs as soon as possible and putting the EMC requirements into the enterprise standards of products.