期刊文献+

板翅式回热器试验与数值模拟研究 被引量:1

Numerical simulation and experimental study on plate-fin recuperator in microturbine
下载PDF
导出
摘要 选取圆弧截面平直翅片板翅式回热器芯部中间冷热流体各两层作为控制单元体,引进对称面和内部耦合方法建立数学模型,应用Fluent软件对单元体进行三维数值模拟,得出了芯体内部的温度场、流场和压力场.对回热器芯体内部的换热和流动情况进行分析,得出了换热性能准则关系式和阻力性能准则关系式.通过对回热器运用稳态等流量进行传热性能和阻力性能试验,得出了相应的换热和阻力准则关系式,并将数值模拟结果与试验所得结果进行了对比分析. Take two layers of hot air and cold air respectively of mandril of plate-fin recuperator which has plain fin with arc section as control element volume. Establish mathematical model by introducing symmetry plane and interior coupling. Carry out three-dimensional numerical simulation of the control element volume by use of Fluent software so as to obtain temperature field, flow field and pressure field of mandril. Analyse the performance of heat transfer and fluid flow. Get criterion relational expression of heat transfer and criterion relational expression of resistance. Put the recuperator to heat transfer performance and resistance performance test by adopting constant mass flow method of steady state, then analyse and treat the test data to get corresponding criterion relational expressions of both heat transfer and resistance. Compare the numerical simulation result with the test result.
出处 《上海理工大学学报》 CAS 北大核心 2009年第2期177-182,共6页 Journal of University of Shanghai For Science and Technology
基金 上海市科学技术委员会资助项目(08195802900)
关键词 板翅式回热器 数值模拟 等流量 准则关系式 plate-fin recuperator numerical simulation test with constant mass flow rate criterion relational expression
  • 相关文献

参考文献6

  • 1LAGERSTROM G, XIE M. High performance & cost effective recuperator for micro-gas turbine[C]//Proceedings of ASME Turbo Expo, 2002:1 003 - 1 008.
  • 2徐之平,卢玫,李凌,余敏,崔晓钰,章立新,杨茉.微型燃气轮机回热器[J].动力工程,2003,23(6):2752-2760. 被引量:16
  • 3蔡祖恢.关于紧凑式换热面放热性能测定方法的讨论[J].上海机械学院学报,1980,2(1):95-131.
  • 4SABOYA F E M, SPARROW E M. Local and average transfer coefficients for one row plate fin and tube heat exchanger configurations[J]. Trans ASME, Series C, 1974,96(3) : 265 - 272.
  • 5PATANKAR S V, SPALDING D B. A calculation procedure for heat,mass and momentum transfer in three- dimensinonal parabolic flows [J]. Int J Heat Mass Transfer,1972,15(11) :1 787- 1 806.
  • 6LEONARD B P. A survey of finite differences with up-winding for numerical modeling of the incompressible convective diffusion equation[C] // TAYLOR C, MORGAN K, eds. Computational Techniques in Transient and Turbulent Flows. Swansea: Pineridge Press Limited, 1981 : 1 - 35.

二级参考文献13

  • 1Stasiek J A. Experimental Studies of Heat Transfer and Fluid Flow Across Corrugated Undulated Heat Exchange Surfaces[J]. International Journal of Heat and Mass Transfer, 1998 (41):899-914.
  • 2Ciofalo M, Stasiek J, Collins M W. Investigation of Flow and Heat Transfer in Corrugated Passages- I . Numerical Simulations[J]. Int, J, Heat Mass Transfer, 1996,39(1):165-192.
  • 3Gunnar Lagerstorm, Max Xie. High Performance &. Cost Effective Recuperator for Micro-Gas Turhine[C]. Proceedings of ASME Turbo Expo 2002, June 3-6,2002,Amsterdam, The Netherlands.
  • 4Richard A. Proeschel, Proe 90TM Recuperator for Microturbine Applications[C]. Proceedings of ASME Turbo Expo 2002, June 3-6,2002, Amsterdam, The Netheralnds.
  • 5Utriainen E. Investigation of Some Heat Transfer Surfaces For Gas Turbine Recepeators, Doctoral Thesis, Division of Heat and Power Engineering[D]. Lund Institute of Technology, SE-221000 Lund, Sweeden, 2001.
  • 6Stasiek J. , Ciofalo M. and Collins M.W. Investigation of Flow and Heat Transfer in Corrugated Passages- I . Experimental Results[J]. International Journal of Heat and Mass Transfer, 1996,39(1):149-164.
  • 7Utrianinen E. , Sunden B, Numerical Analysis of Laminar Flow in Corrugated Undulated Ducts [C]. Submitted to Third International Conference on Compact Heat Exchangers and Enhancement Technology for the Process Industries. Davos, Switzerland, 2001,6.
  • 8Utriainen E. , Sunden B. Numberical Analysis of Primary Surface Trapezoidal Cross Wavy Duct[J]. Int J Num.Meth. Heat & Fluid Flow 2000.
  • 9Colin F, McDonald. Low-cost compact primary surface recuperator concept for micro-turbines[J]. Applied Thermal Engineering ,2000(20) :471 -497.
  • 10Utriainen E, Sunden B. Recuperators and Regeneratots in Gas Turbine Systems, to appear in Heat Transfer in Gas Turbine Systems[M]. WIT Press, UK, 2001.

共引文献17

同被引文献19

  • 1张贤安.双金属轧片式翅片管管外对流换热准则关系式研究[J].流体机械,2004,32(7):19-22. 被引量:6
  • 2苏俊林,陈岚,王震坤.分离式热管换热器传热特性研究[J].农机化研究,2006,28(7):161-162. 被引量:7
  • 3ShiMeizhong(史美中),WangZhongzheng(王中铮).PrincipleandDesign of Heat Exchangers [M]. 4th ed. Nanjing: Southeast University Press, 2009.
  • 4PanJihong(潘继红),TianMaocheng(田茂诚).AnalysisandCalculation of Shell and Tube Heat Exchanger [M]. Beijing: Science Press, 1996.
  • 5Wilson E E. A basis of rational design of heat transfer apparatus [J].ASME Journal of Heat Transfer, 1915, 37:47-70.
  • 6Femfindez-Seara J, Uhia F J, Sieres J, Campo A. Experimental apparatus for measuring heat transfer coefficients by the Wilson plot method [J]. European Journal of Physics, 2005, 26: 1-11.
  • 7Kumar R, Varma H K, Agrawal K N, Mohanty B. A comprehensive study of modified Wilson plot technique to determine the heat transfer coefficient during condensation of steam and R-134a over single horizontal plain and finned tubes [J]. Heat Transfer Engineering, 2011, 22:3-12.
  • 8Rose J W. Heat-transfer coefficients, Wilson plots and accuracy of thermal measurements [J]. Experimental Thermal and Fluid Sciences, 2004, 28:77-86.
  • 9Khartabil H F, Christensen R N. An improved scheme for determining heat transfer correlations for heat exchanger regression models with three unknowns [J]. Experimental Thermal and Fluid Sciences, 1992, 5:808-819.
  • 10Zdaniuk, Gregory J. A comparison of artificial neural networks and symbolic-regression-based correlations for optimization of helically finned tubes in heat exchangers [J]. Journal of Enhanced Heat Transfer, 2011, 18 (2): 115-125.

引证文献1

二级引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部