摘要
分析了1500横切机生产切边铝板时铝板对角线存在偏差的原因,提出了切边铝板对角线偏差控制途径,表明切边铝板对角线超差废品可控制在极小的范围。
The reasons for the existence of diagonal deviation on aluminium plate after it is trimmed by 1500 cut-to-length line is analyzed in this paper. The way for diagonal control of the trimmed aluminum plate is shown which indicates that the rejected trimmed plate with diagonal oversize can be controlled within a very tiny range.
出处
《轻合金加工技术》
CAS
北大核心
2009年第6期24-26,共3页
Light Alloy Fabrication Technology
关键词
1500横切机
切边铝板
立辊对中
对角线偏差
1500 cut-to-length line
trimmed aluminium plate
aligning of the edger
diagonal deviation