反导火炮试验技术分析

Analysis on Test Technology of Antimissile Gun

针对某型反导火炮随动系统和射击控制系统在设计定型试验中遇到的技术难题,对危界击发和撞限滑行角过大等问题进行了分析,并为解决这些问题提出了技术措施。在试验实施过程中,采用每组弹装入弹鼓后,再后退10个弹位,然后进行射击试验的方法,以尽量多地得到有效弹数。实际射击曲线表明,该方案取得了很好的效果。试验结果验证了该技术措施的可行性和有效性,为此类武器试验积累了宝贵经验。

Aimed at the difficult technical problems of the servo system and fire control system of a type of antimissile gun in the design and qualification tests, the problems such as gun fire in danger area and slide angle beyond the limit too large were analyzed, and the technical measures were proposed to solve these problems. In the course of shooting tests, after each group of projectiles were feeded into the drum magazine, by means of drawing back 10-projectile position, the fire tests were then carried out to acquire effective shooting amounts as many as possible. The actual fire curves showed that these measures have very good effectiveness. The test results verified the feasibility and effectiveness of these measures and accumulated the invaluable experience for this type of weapon system.