摘要
分析电梯入口盖板的结构特点及成型工艺,利用Moldflow/MPI软件确定塑料件的浇口位置和数量,建立塑料件的热流道浇注系统,进行了塑料件的注射成型CAE分析,并论述了塑料件的模具结构及模具工作过程。该模具已投入大批量生产,生产的塑料件质量符合客户要求。
The structural feature and forming technology of the elevator inlet cover were analyzed. By using Moldflow/MPI software, the gate positions and quantity of the plastic part were ascertained, the hot runner system of the plastic part was created and CAE analysis of injection molding was performed. The mould structure was detailedly designed on the basis of the above CAE analysis and the working process of the injection mould was discussed. The injection mould was already in mass production and the plastic parts produced could meet the customers＇technical requirements.
出处
《工程塑料应用》
CAS
CSCD
北大核心
2009年第8期72-76,共5页
Engineering Plastics Application
基金
广东省教育部产学研结合项目(2008B090500044)
广东省科技计划项目(工业攻关)(2008B010400001)
