摘要
采用相同生产工艺、不同聚合度的两种树脂进行复配,研究各复配比例下聚氯乙烯增塑糊初始黏度以及黏度随时间的变化情况。结果表明,当高聚合度糊树脂PSH-10与低聚合度糊树脂CPM-31的配比为20/80时,糊黏度在各时间段最低;当PSH-10/CPM-31=50/50时,糊黏度稳定性最差;高聚合度糊树脂PSH-10基体中引入低聚合度糊树脂CPM-31(CPM-31含量小于50%)时,对增塑糊黏度的影响要比低聚合度糊树脂CPM-31中引入高聚合度糊树脂PSH-10(PSH-10含量小于50%)的影响明显;聚合度分布宽不利于增塑糊黏度的稳定。
Viscosity and stability over time of PVC plastisols were studied based on compounds of a high- and a low-degree polymerization PVC paste resins, PSH-10 and CPM-31. When PSH-10/ CPM-31=20/80, the plastisol provided the lowest viscosity. When PSH-10/CPM-31 =50/50, the worst stability was observed. The viscosity and stability of PVC plastisols were more sensitive to the content of low-degree polymerization component.
出处
《中国塑料》
CAS
CSCD
北大核心
2009年第9期63-66,共4页
China Plastics
基金
国家科技支撑计划(2007BAE10B03)
贵州省科技计划[黔科合计省(2008)7005]
关键词
聚氯乙烯
增塑糊
复配
黏度
稳定性
poly(vinyl chloride)
plastisols
compounding
viscosity
stability