期刊文献+

电感寄生电容对电子镇流器启动的影响 被引量:2

Influence of Self-Capacitance of Inductor on Electronic Ballast Ignition
下载PDF
导出
摘要 针对电子镇流器启动时的可靠性要求研究了电子镇流器的谐振方法。对串联谐振、并联谐振、串并联谐振3种谐振方法进行比较后,选择了串并联谐振法,并分析研究了这种谐振方法存在的问题。为了使电子镇流器可靠启动,必须提供足够高的启动电压。通过研究串并联谐振电路启动时各种参数,发现电感的寄生电容对启动电压影响特别大,因此针对这种现象对原有方法进行了改进,使启动电压达到3kV以上,从而能够可靠地将灯点亮。介绍了滑频启动方法,并对该方法加以改进,实现了可靠点灯。 This article studies the reliability of electronic ballast ignition.With the research on the resonance means in electronic ballast,three means i.e. resonance in series,resonance in parallel,resonance in series-parallel are compared, and last one is chosen.Tbe research on the problem of the selected means is carried out.In order to make the ignition reli- able,enough high voltage must be supplied.Researching on the parameter in series-parallel connection circuit diseoveres that the influence of parasitic-capacitance of inductor on electronic ballast ignition is very prodigious, so some bet-terments are made to make the ignition voltage reach more than 3 kV, and to ignit the light very reliably.
机构地区 哈尔滨工业大学
出处 《电力电子技术》 CSCD 北大核心 2009年第10期91-93,共3页 Power Electronics
关键词 寄生电容 镇流器 启动 parasitic-capacitance ballast ignition
  • 相关文献

参考文献4

  • 1Yeong-Lin Lai,Kuo-Hua Hsu.A New Pinched-Off Cold-FET Method to Determine Parasitic Capacitances of FET Equivalent Circuits[J].IEEE Trans. on Microwave Theory and Techniques, 2001,49(8) : 1410-1418.
  • 2Timothy C Neugebauer,David J Perreault.Parasitic Capacitance Cancellation in Filter Inductors[J].IEEE Trans. on Power Electronics, 2006,21 ( 1 ) : 282-288.
  • 3K Piboonwattanakit,W Khan-ngem.Parasitic Capacitance Cancellation of Filter in Power Supply Using Mutual Capacitance Technique[J].IEEE Trans. on Electrical Engineering/Electronics, Computer,Telecommunications and Information Technology.14-17 May 2008, (2) : 1025-1028.
  • 4Antonio Massarini,Marian K Kazimierczuk.Self-Capacitance of Inductors[J].IEEE Trans. on Power Electronics, 1997,12 (4) :671-676.

同被引文献6

引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部