期刊文献+

串联谐振模式下介质阻挡放电动态负载及工作特性研究 被引量:1

Dynamic Loads and Working Characteristics of DBD in Series Resonance Mode
下载PDF
导出
摘要 分析了采用串联谐振中频逆变高压电源供电的介质阻挡放电装置的工作原理及其负载输入电压的频率特性,并对其动态负载及工作特性进行了试验研究。结果表明:负载的介质等效电容随着放电功率的增加而增大,气隙等效电容则随放电功率的增加而减小,气隙及介质等效电容的串联值随放电功率的变化较小;上述系统在负载气隙击穿前后存在两个不同的谐振频率,系统工作在气隙击穿前的谐振频率放电最易启动,而电源频率接近气隙击穿后的回路谐振频率时有利于系统放电功率的提高,为介质阻挡放电型低温等离子体反应器的设计及改进提供了理论及试验依据。 For the dielectric barrier discharge device whose power was supplied with the series resonance medium-frequency inverter, the working principle and load voltage frequency were analyzed and the dynamic load and working characteristic were researched. The results show that, with the increase of discharge power, the dielectric equivalent capacitance increases and the gap equivalent capacitance decreases, but the series capacitance of them has little difference. The above-mentioned device has two different resonance frequencies, which are distributed before and after the breakdown of gap. When the device works at the former resonance frequency, the discharge starts easily. When the device works at the latter resonance frequency, the system discharge power easily increases. The conclusions provide the theoretical and experimental evidence for designing the DBD- typed non-thermal plasma reactor.
出处 《车用发动机》 北大核心 2010年第1期37-40,共4页 Vehicle Engine
基金 国家自然科学基金资助项目(50776041) 江苏省动力机械清洁能源与应用重点实验室开放基金项目(QK08004)
关键词 低温等离子体 串联谐振 介质阻挡放电 负载特性 氮氧化物 排放控制 non-thermal plasma series resonance dielectric barrier discharge load characteristic oxides of nitrogen emission control
  • 相关文献

参考文献5

二级参考文献21

  • 1蔡忆昔,吴江霞,赵卫东,傅娟娟,朱明健.非平衡等离子体处理柴油机有害排放[J].江苏大学学报(自然科学版),2005,26(2):121-124. 被引量:7
  • 2[1]B.Eliasson, U. Kogelschatz. Modeling and Applications of Silent Discharge Plasma. IEEE TRANS. ON PLASMA SCIENCE,, 1991, 19(2):309~323.
  • 3[2]Ulrich Kogelschatz, et al.. FROM OZONE GENERATION TO FLAT TELEVISION SCREENS~History and Future Potential of Dielectric-Barrier Discharges. The 14th ISPC 1999:3~5.
  • 4[3]陈壁光,沈能士编著.电器试验和测量技术.北京:中国电力出版社,1999.
  • 5Senichi Masuda, Shunsuke Hosokawa, Ikuo Tochizawa. Surface treatment of plastic material by pulse corona induced plasma chemical process-PPCP[J]. IEEETrans. IA. 1975, 30(2): 328-335.
  • 6Akagi H, Nabae A. A voltage-source inverter using IGBT's for a 50kHz 10kV corona surface treater[C] . IEEE/IAS Annual Meeting. Pittsburgh, PA, 1989. 1164-1169.
  • 7Dmowski A, Bugyi R, Szewezyk P. Anovel series-resonant dc/dc converter with full control of output voltage at no-load conditioncomputer simulation based design aspects[C]. IEEE/IAS Dearbom,MI, Annual Meeting. 1992. 924-928.
  • 8Roy P P. Analysis of the series resonant converter using a frequency domain model [C]. Proc. IEEE PESC. Cambridge, MA, 1991.1164-1169.
  • 9Kosocha L A, Snyder H R, Miziolek A W, et al. Development of non-thermal plasma reactor technology for control of atmospheric emissions: final report for serdp project cp-1038 [ R ]. Los Alauos National Laboratory Army Research Laboratory, MeMaster University, 2000.
  • 10John Hoard. Plasma-catalysis for diesel exhaust treatment: current state of the art[J]. SAE, 001-01-0185.

共引文献88

同被引文献16

引证文献1

二级引证文献3

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部