摘要
The ferrites of PC30 （Mn-Zn ferrites） were prepared by using a dry processing route. The effect of Mn-Zn ferrites doped with H3BO3 was investigated on the basis of microstructure analysis. The results of the samples doped with H3BO3 less than 5 × 10^-5 showed that the doping had no significant effect on power loss, initial permeability, fine grain microstructure, and density of Mn-Zn ferrites. With the further increase in H3BO3 doping （up to 1 × 10 ^-4 ）, the microstructure of Mn-Zn ferrites is in the critical state between fine grain and ＂sandwich＂, and the initial permeability and density of Mn-Zn ferrites begin falling quickly; the increased H3BO3 doping also results in deteriorated power loss properties. Thus, the control of the boron content in iron oxide is of utmost importance for the quality of Mn-Zn ferrites in producing process.
The ferrites of PC30 （Mn-Zn ferrites） were prepared by using a dry processing route. The effect of Mn-Zn ferrites doped with H3BO3 was investigated on the basis of microstructure analysis. The results of the samples doped with H3BO3 less than 5 × 10^-5 showed that the doping had no significant effect on power loss, initial permeability, fine grain microstructure, and density of Mn-Zn ferrites. With the further increase in H3BO3 doping （up to 1 × 10 ^-4 ）, the microstructure of Mn-Zn ferrites is in the critical state between fine grain and ＂sandwich＂, and the initial permeability and density of Mn-Zn ferrites begin falling quickly; the increased H3BO3 doping also results in deteriorated power loss properties. Thus, the control of the boron content in iron oxide is of utmost importance for the quality of Mn-Zn ferrites in producing process.
