期刊文献+

72A帘线钢连续冷却转变规律的分析 被引量:6

Pattern of continuous cooling transformation of 72A cord steel
下载PDF
导出
摘要 采用热膨胀法在Gleeble-1500热模拟实验机上测定72A帘线钢的连续冷却转变(CCT)曲线,并分析开始冷却温度为900℃时不同冷却速度下帘线钢的室温组织和连续冷却转变规律。结果表明,随着冷却速度的加快,72A帘线钢的转变开始温度降低、完成转变时间缩短、珠光体片层间距变细,但连续冷却转变条件下得到钢中珠光体组织的均匀性较差。 The continuous cooling transformation curve of 72A cord steel has been drawn by Gleeble- 1500 thermal simulation machine using the thermal dilation method. The influence of starting cooling temperature of 900 ℃ and cooling rate on room temperature structure and properties of steel is analyzed. The result shows that, with the acceleration of cooling, the starting temperature of transformation of the cord steel begins to fall, the time needed to complete the transformation becomes short, and the distance of pearlite lamina decreases, but the homogeneity of pearlitic structure in the steel is poor under the condition of continuous cooling transformation.
出处 《武汉科技大学学报》 CAS 2010年第1期43-46,共4页 Journal of Wuhan University of Science and Technology
关键词 72A帘线钢 连续冷却转变 珠光体 72A cord steel continuous cooling transformation pearlite
  • 相关文献

参考文献3

二级参考文献5

  • 1Harizaki A Z,Hodgson P D,Yue S.Hot Deformation Characteristics of Si-Mn TRIP Steels with and without Microalloy Additions[J].ISIJ Inter,1995,35(3):324-331.
  • 2Sugimoto K,Nagasaka A,Kobayashi M,et al.Effects of Retained Austenite Parameters on Warm Stretch-Flange-Ability in TRIP-Aided Dual Phase Sheet Steels[J].ISIJ Inter,1999,39(1):56-63.
  • 3Gunter Flemming.Present and Future CSP Technology Expands Product Range[J].Aise Steel Technology,2000,(1):53-57.
  • 4邹宏辉,符仁钰,李麟,朱晓东.低碳Si-Mn系TRIP钢的热处理工艺对组织的影响[J].金属热处理,2003,28(1):59-62. 被引量:26
  • 5赵金福,明旭光,欧立晋,崔玉琴,杜英敏.控轧工艺对TRIP薄板组织与性能的影响[J].钢铁,1992,27(11):24-27. 被引量:15

共引文献31

同被引文献35

  • 1余万华,杜雁冰,卿俊峰,王琨,王绍斌,刘勇.高速线材风冷段温度及相变藕合模型开发[J].材料热处理学报,2007,28(2):132-135. 被引量:9
  • 2Sebastien Hollinger, Eric Depraetere, Olivier Giroux. Wear mechanism of tungsten carbide dies during wet drawing of steel tyre cords[J]. Wear, 2003, 255: 1 291-1 299.
  • 3中华人民共和国黑色冶金行业标准.YB/T169--2000高碳钢盘条索氏体含量金相检测方法[S].北京:中国标准工业出版社,2001.
  • 4中华人民共和国国家标准.GB/T157492008定量金相测定方法[S].北京:中国标准工业出版社,2009.
  • 5刘宏玉,郑建强,李玉华,等.帘线钢控冷工艺研究[J].材料热处理技术,2010,39(16) :31-36.
  • 6林薏国,傅代直.钢的奥氏体转变曲线原理、测试与应用[M].北京:机械工业出版社,1988.
  • 7Kumar A,McCulloch C, Hawbolt E B,et al. Model-ling thermal and microstructural evolution on runouttable of hot stripMater Sci Technol,1991,7(4).360-368.
  • 8Militzer M, Pandi R,Hawbolt E B,et al. Model-ling the phase transformation kinetics in low-carbonsteels[C]. Hot Workability of Steels and Light Al-loys-Composites, Montreal; 1996. 373-380.
  • 9Militzer M,Pandi R, Hawbolt E B. Ferrite nuclea-tion and growth during continuous cooling[J], Met-allurgical and Materials Transactions A, 1996, 27(6):1547-1556.
  • 10Hawbolt E B,Chau B,Brimacombe J K. Kineticsof austenite-ferrite and austenite-pearlite transfor-mations in a 1025 carbon steel [J]. MetallurgicalTransactions A, 1985, 16(4) : 565-578.

引证文献6

二级引证文献13

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部