摘要
结合ISO 281:2007讨论了黏度比κ通过aISO对轴承额定寿命计算的显著影响,澄清了标准中对黏度比κ两种计算方法适用前提的含糊描述。通过分析计算表明,在滚动接触表面超精研加工和一般运行条件下,黏度比κ应该按照黏度的比值进行计算,否则应该按照油膜参数进行计算。
Combined with IS0 281: 2007, the great influence of viscosity ratio κ on bearing rating life calculation through also is discussed, vague description on the preconditions for the calculation of κ is clarified. Upon calculation and analysis, viscosity ratio κ should be calculated by the ratio of viscosity for super finishing contact surfaces and moderate bearing running speed and load, otherwise, it should be calculated by oil film parameter.
出处
《轴承》
北大核心
2010年第3期4-7,共4页
Bearing
关键词
滚动轴承
黏度比
油膜参数
寿命修正系数
额定寿命
rolling bearing
viscosity ratio
oil film parameter
life modified factor
rating life