摘要
利用现场可编程门阵列(FPGA),设计了用于纳秒泵浦探测系统上的双激光同步控制器。将来自飞秒激光器的20 Hz同步信号二分频产生参考信号用于触发光纤光谱仪,同时根据PC机对系统的延时设置产生用于触发纳秒激光器Nd:YAG的lamp触发信号、Q-switch触发信号。介绍了双激光器同步控制器应用的纳秒泵浦探测系统原理,详细给出了具体各功能模块的设计。对实验测得的各路触发信号分析表明,本文的设计方案是可行的。
A FPGA-based dual-laser synchronization control system used in the nanosecond-pumped laser system is realized.The 2-frequency division of the 20 Hz synchronized signal from the femtosecond-laser is produced for triggering the fiber spectrograph.Meanwhile,according to the delay time set by the PC,the signals for triggering the nanosecond-laser are generated,including the lamp triggering signal and the Q-switch signal.The principle of the nanosecond pump detection system for the application of double-laser synchronizing control is described.The design of each module is presented in detail,and the analysis on the triggering signals of each channel from the experiment shows that it is feasible.
出处
《光电子.激光》
EI
CAS
CSCD
北大核心
2010年第2期200-203,共4页
Journal of Optoelectronics·Laser
基金
高等学校科技创新工程重大项目培育基金资助项目(706017)