4Liu X W. Five-axis NC cylindrical milling of sculptured surfaces. CAD, 1995, 27(12): 887～894.
5Redonnet J M, Rubio W, Dessein G. Side milling of ruled surfaces:Optimum positioning of the milling cutter and calculation of interference. International Journal for Advanced Manufacturing Technology, 1998, 14:459～465.
6Sanjeev B, Stephen M, Cornelia M. Flank milling with flat end cutter. CAD, 2003, 35:293～300.
7Cornelia M, Sanjeev B, Stephen M. Triple tangent flank milling of ruled surfaces. CAD, 2004, 36:375～378.
8Pigel L, Tiller W. The NURBS Book. Berlin: Springer,1995.
9Ma W Y, Kruth J P. Parameterization of randomly measured points for least squares fitting of B-spline curves and surfaces. CAD, 1995, 27(9): 663～675.
