期刊文献+

FBM模型在栅中翼形空化流动计算中的应用 被引量:4

APPLICATION OF THE FBM MODEL FOR THE COMPUTATIONS OF CAVITATION FLOW AROUND A CASCADE HYDROFOIL
原文传递
导出
摘要 以单排Clark-Y型水翼叶栅为例,采用滤波器湍流模型(FBM)对绕栅中水翼的空化流动进行数值研究。雷诺数和空化数结合水洞实验工况进行设置,滤波尺寸根据加密区最大网格尺度取出经验值,模型通过二次开发方法嵌入至CFX软件中。对栅中水翼空化流动特性的分析表明,栅中翼形前缘和后缘部分均可能发生准周期性的空泡脱落现象,其脱落周期随空化数的降低而变大;前缘和后缘空泡的脱落均对翼型阻力产生影响,但前者影响更大,随空化数的降低,脱落现象逐渐局限于后缘部分,使翼型所受阻力的波动大为减弱。 The cavitation flow around a cascade hydrofoil was numerical studied with the filter-based turbulence model(FBM) based on the Clark-Y cascade hydrofoil.The Reynolds number and the cavitation number were set according to the water tunnel experiment and the empirical value of the filter size was given based on the largest grid size of the refined region.Through second development, the FBM model was embed in the CFX software.The results demonstrate that the phenomenon of quasi-periodical cavity shedding will occur near the leading part and the trailing part of the cascade hydrofoil,and the shedding period will increase with the decrease of cavitation number;the cavity shedding in both parts can influence the drag acting on the hydrofoil,but the leading part shedding is dominant;with the decrease of cavitation number,the shedding will be gradually limited into the trailing part,and the drag fluctuating will be weaken to a great extent.
出处 《工程热物理学报》 EI CAS CSCD 北大核心 2010年第5期777-780,共4页 Journal of Engineering Thermophysics
基金 国家自然科学基金资助项目(No.50679001) 高等学校博士学科点专项科研基金(No.20070007047)
关键词 滤波器模型 栅中水翼 空化流动 空泡脱落 filter-based model cascade hydrofoil cavitation flow cavity shedding
  • 相关文献

参考文献7

二级参考文献59

  • 1王国玉,方韬,曹树良,韩占忠,IKOHAGI TOSHIAKI.非定常粘性空化流动模型及其数值计算[J].工程热物理学报,2004,25(5):783-785. 被引量:13
  • 2Wang, G.Y., Senocak, I., Shyy, W., Ikohagi, T., Cao, S.L.: Dynamics of attached turbulent cavitating flows. Prog. Aerosp. Sci. 37, 551-581 (2001)
  • 3Brennen, C.E.: Cavitation and Bubble Dynamics. Oxford University Press, New York (1995)
  • 4Rood, E.E: Review-mechanisms of cavitation inception. J. Fluids Eng. 113, 163-175 (1991)
  • 5Kawanami, Y., Kato, H., Yamauchi, H., Tanimura, M., Tagaya, Y.: Mechanism and control of cloud cavitation. J. Fluids Eng. 119, 788-794 (1997)
  • 6Leger, A.T., Ceccio, S.L.: Examination of the flow near the leading edge of attached cavitation, part 1. detachment of two-dimensional and axisymmetric cavities. J. Fluid Mech. 376, 61-90 (1998)
  • 7Delange, D.F., Debruin, G.J.: Sheet cavitation and cloud cavitation, re-entrant jet and three-dimensionality. Appl. Sci. Res. 58, 91-114 (1998)
  • 8Kjeldsen, M., Arndt, R.E.A., Effertz, M.: Spectral characteristics of sheet/cloud cavitation. Trans. ASME J. Fluids Eng. 122, 481-487 (2000)
  • 9Hrubes, J.D.: High-speed imaging of supercavitating underwater projectiles. Exp. Fluids 30, 57--64 (2001)
  • 10Shen, Y., Dimotakis, P.: The influence of surface cavitation on hydrodynamic forces. In: Proceedings 22nd ATTC, St. Johns (1989)

共引文献6

同被引文献45

  • 1黎耀军,沈金峰,刘竹青,唐学林,张志民.轴流泵轮缘间隙非定常流动的大涡模拟[J].农业机械学报,2013,44(S1):113-118. 被引量:13
  • 2梁开洪,张克危,许丽.轴流泵叶顶间隙流动的计算流体动力分析[J].华中科技大学学报(自然科学版),2004,32(9):36-38. 被引量:47
  • 3BENJAMIN T B, ELLIS A T. The collapse of cavitation bubbles and the pressures thereby produced against solid boundaries [ J]. Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Science, 1966, 260( 1110): 221 -240.
  • 4CHAPMAN R B, PLESSET M S. Nonlinear effects in the collapse of a nearly spherical cavity in a liquid[J]. Journal of Fluids Engineering, 1972, 94(1): 142-145.
  • 5YU Xianjun, LIU Baojie, L1ANG Haokang. Characteristics of the tip leakage vortex in a low-speed axial compressor[J]. AIAA Journal, 2007, 45(4) : 870 - 878.
  • 6ZHANG Desheng, SHI Weidong, van ESCH B P M B, et al. Numerical and experimental investigatiun of tip leakage vortex trajectory and dynamics in an axial flow pump[J]. Computers & Fluids, 2015, 112:61 -71.
  • 7GOPALAN S, ABRAHAM B M, KATZ J. The structure of a jet in cross flow at low velocity ratios[J]. Physics of Fluids, 2004, 16(6) : 2067 -2087.
  • 8ZHANG Desheng, SHI Weidong, PAN Dazhi, et al. Numerical and experimental investigation of tip leakage vortex cavitation patterns and mechanisms in an axial flow pump[J]. ASME Journal of Fluids Engineering, 2015, 137(12) : 121103 -1 -121103 -14.
  • 9ZHANG Desheng, PAN Dazhi, SHI Weidong, et al. Study on tip leakage vortex in an axial flow pump based on modified shear stress transport k-a turbulence model[ J]. Thermal Science, 2013, 17 (5) : 1551 - 1555.
  • 10WU H, SORANNA F, MICHAEL T, et al. Cavitation in the tip region of the rotor blades within a waterjet pump[ C]//ASME Fluids Engineering Conference, 2008, 8 : 10 - 14.

引证文献4

二级引证文献20

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部