期刊文献+

Tuning of fuzzy PID controller for Smith predictor 被引量:11

Tuning of fuzzy PID controller for Smith predictor
下载PDF
导出
摘要 An analytical tuning method was proposed for fuzzy PID controller used in Smith predictor in order to extend its application and improve its robustness. The fuzzy PID controller was expressed as a sliding mode control. Based on Lyapunov theory, Smith predictor was analyzed in time domain. The parameters of the fuzzy PID controller can be obtained using traditional linear control theory and sliding mode control theory. The simulation experiments were implemented. The simulation results show that the control performance, robustness and stability of the fuzzy PID controller are better than those of the PID controller in Smith predictor. An analytical tuning method was proposed for fuzzy PID controller used in Smith predictor in order to extend its application and improve its robustness. The fuzzy PID controller was expressed as a sliding mode control. Based on Lyapunov theory, Smith predictor was analyzed in time domain. The parameters of the fuzzy PID controller can be obtained using traditional linear control theory and sliding mode control theory. The simulation experiments were implemented. The simulation results show that the control performance, robustness and stability of the fuzzy PID controller are better than those of the PID controller in Smith predictor.
出处 《Journal of Central South University》 SCIE EI CAS 2010年第3期566-571,共6页 中南大学学报(英文版)
基金 Project(70473068) supported by the National Natural Science Foundation of China Project(05JZD00024) supported by the Major Subject of Ministry of Education, China
关键词 SMITH预估控制器 模糊PID控制器 LYAPUNOV理论 整定 滑动模式控制 控制理论 史密斯预估 仿真实验 Smith predictor Lyapunov theory fuzzy PID controller robustness
  • 相关文献

参考文献20

  • 1KAYA I.IMC based automatic tuning method for PID controllers in a Smith predictor configuration[J].Computers and Chemical Engineering,2004,28(3):281-290.
  • 2CAMACHO O,FRANCISCO D L C.Smith predictor based-sliding mode controller for integrating processes with elevated dead-time[J].ISA Transactions,2004,43:257-270.
  • 3CHEN Ning,LIU Wei-ying,GUI Wei-hua.Delay-dependent decentralized robust control for power systems based on output feedback[J].J Cent South Univ:Science and Technology,2009,40(3):711-718.(in Chinese).
  • 4RONG Hui-gui,ZHOU Ning,JIN Min,WU Jia-xin.Research on service-oriented framework of interface prototype driven development[C] // The 1st IEEE Inter Conf on Computer Science and Software Engineering.Wuhan,2008:552-557.
  • 5NORMEY J E,CAMACHO E F.Dead time compensators:A survey[J].Control Engineering Practice,2008,16(4):407-428.
  • 6Zhang Guanghui,Qian Feng,Shao Huihe.Robust tuning method for modified smith predictor[J].Journal of Systems Engineering and Electronics,2007,18(1):89-94. 被引量:2
  • 7GEORGE K I M,HU B G,RAYMOND G G.Analysis of direct action fuzzy PID controller structures[J].IEEE Trans Syst,Man,Cybern B,1999,29(3):371-388.
  • 8LI H X,TSO S K.Quantitative design and analysis of fuzzy PID control:A step towards autotuning[J].International Journal of Systems Science,2000,31(5):545-553.
  • 9GEORGE K I M,HU B G,RAYMOND G G.Two-level tuning of fuzzy PID controllers[J].IEEE Trans Syst,Man,Cybern B,2001,31(2):263-269.
  • 10RAO A S,CHIDAMBARAM M.Analytical design of modified smith predictor in a two-degrees-of-freedom control scheme for second order unstable processes with time delay[J].ISA Transactions,2008,47:407-419.

二级参考文献1

共引文献1

同被引文献85

引证文献11

二级引证文献34

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部