摘要
首先控制聚苯乙烯纳米球(PS球)乳液在基片上的干燥温度,采用自组装方法,使用单一粒径的PS球制备出单层的PS球亚稳态正方排列结构模板。然后,在模板上通过磁控溅射法沉积一层银膜。利用纳米球光刻技术,去掉PS球模板得到二维正方点阵排列的准正方形银纳米颗粒阵列结构。
Firstly,a single layer of monodispersed polystyrene (PS) spheres of square lattice was prepared as template on a glass substrate by a self-assembly by via controlling drying temperature.Then,a silver film was deposited over the template on the substrate by magnetron sputtering.After removing the PS spheres template from the substrate,a novel two-dimensional square lattice array of quasi-square silver nanoparticles was thus attained via nanosphere lithography.
出处
《光谱实验室》
CAS
CSCD
北大核心
2010年第4期1579-1582,共4页
Chinese Journal of Spectroscopy Laboratory
基金
国家科技部国际科技合作与交流专项项目(2008DFA51230)
国家重大科学研究计划(973)子项目(2007CB936603)
国家自然科学基金(No.60776007)资助
关键词
纳米球光刻
正方排列
准正方形银纳米颗粒
Nanosphere Lithography
Square Lattice Arrays
Quasi-Square Silver Nanoparticles