摘要
应用储层地质随机建模方法,对濮城油田某一地区储层参数进行建模计算,建立相应的储层参数预测模型。在此预测模型的基础上,研究分析了储层孔隙度、渗透率、含油饱和度在平面上的分布规律。并从实际出发,依据储层的水驱规律,分析出剩余油的分布情况,找出剩余油的富集区主要分布在未被水淹的前远砂体及远砂砂体。通过挖潜措施的实施,提高了老油田的产量。
Using the method of random modeling with geologic data, the reservoir parameters for a certain area in Pucheng oil field are measured and calculated, and then the model is set up for predicting the reservoir parameters correspondingly. Based on the modeling results, the distribution laws are studied and analyzed for porosity and permeability of reservoir and oil-bearing saturation on the horizontal zone. The distributed conditions of residual oil are analyzed and known with the law of water-displacement-residual oil practically. It is found that the oil enriched zones are primary located in the unflooded far front sand body and frontier sand body. The production of maturing fields are increased by taking the measures of increment of potential resources.
出处
《断块油气田》
CAS
1999年第3期42-44,共3页
Fault-Block Oil & Gas Field
关键词
建模
孔隙度
渗透率
含油饱和度
剩余油
模拟
Random modeling, Formation parameter, Porosity, Permeability, Oil saturation,Remaining oil, Tap production potential