期刊文献+

常温和高温环境下电磁继电器触点侵蚀及失效模式分析 被引量:9

Contact Erosion and Failure Mode Analysis of Electromagnetic Relay Under the Circumstance of Room and High Temperatures
下载PDF
导出
摘要 环境温度是影响电磁继电器触点侵蚀的一个重要因素。根据相同负载不同温度(常温+20℃和高温+125℃)下继电器10万次动作后的对比试验结果,对触点的侵蚀情况和测得的相关数据进行分析,解释两种环境温度下触点侵蚀不同及导致的测试结果差异。同时建立电磁继电器的静、动态特性模型,仿真分析触点侵蚀不同对相关参数的影响。最后推测两种温度下触点的不同失效模式并给出应采取的预防和改进措施。 Ambient temperature is an important factor influencing contact erosion of electromagnetic relay. In this paper,based on results of 1×10^5 cycle operations with the same load under different temperatures (room temperature:+20℃,high temperature:+125℃),the erosion of contacts and the data of tests are analyzed,and the reasons of different contact erosions and different results of tests under the two ambient temperatures are given. Then,the static and dynamic model of electromagnetic relay is built; some parameters under the influence of different contact erosions are calculated and analyzed. Finally,the different failure modes of contacts are predicted under the two ambient temperatures,and some measures of prevention and improvement are given.
出处 《电工技术学报》 EI CSCD 北大核心 2010年第9期80-86,共7页 Transactions of China Electrotechnical Society
基金 民用航天科研预先研究资助项目(B1220062302)
关键词 电磁继电器 环境温度 失效模式 触点侵蚀 Electromagnetic relay ambient temperature failure mode contact erosion
  • 相关文献

参考文献11

  • 1李震彪,张欢,梁盼望,徐坚.电源电压对继电器闭合与分断时间及触点弹跳的影响[J].华中科技大学学报(自然科学版),2008,36(12):104-107. 被引量:6
  • 2李震彪,张欢,郑必成,徐坚.电源电压和触点材料对继电器分断时间的影响[J].低压电器,2008(15):1-3. 被引量:3
  • 3李震彪,黄良,吴细秀,魏梅芳.42V汽车继电器触点电弧特性[J].低压电器,2007(15):1-4. 被引量:5
  • 4Jemaa N B, Doublet L, Morin L, et al. Break arc study for the new electrical level of 42V in automotive applications[J]. IEEE Trans. on Compon. Packag. Technol., 2002, 25(3): 420-426.
  • 5Sallais D, Jemma N B, Carvou E. An arc study at high DC current levels in automotive applicatioin[J]. IEEE Trans. on Compon. Packag. Technol., 2007, 30(3): 540-545.
  • 6Jemma N B. Short arc duration laws and distributions at low current (< 1A) and voltage (14~42VDC)[J]. IEEE Trans. on Compon. Packag. Technol., 2001, 24(3): 358-362.
  • 7Witter G, Polevoy I. Contact erosion and material transfer for contacts in automotive relays[C]. Proceedings of the 42nd IEEE Holm Conference on Electrical Contacts, 1996, 223-228.
  • 8程礼椿,李震彪,邹积岩.再论汽车继电器触点电侵蚀[J].汽车电器,1997(4):5-9. 被引量:2
  • 9Chen Z K, WiRer G. A comparison of contact erosion for opening velocity variations for 13 volt circuits[C]. Proceedings of the 52th IEEE Holm Conference, 2006 15-20.
  • 10Jemaa N B, Morin L, Benhenda S,et al. Anodic to cathodic arc transition according to break arc lengthening[J]. IEEE Trans. on Compon. Packag. Technol., 1998, 21(4): 599-603.

二级参考文献21

  • 1徐勇.42V汽车继电器[J].机电元件,2004,24(2):54-56. 被引量:8
  • 2宋晓亮,李震彪,狄美华,吴细秀.汽车继电器燃弧时间分析[J].低压电器,2005(8):6-10. 被引量:5
  • 3李震彪,郑必成,张欢.继电器熔焊特性及其与触点分断操作的关系[J].华中科技大学学报(自然科学版),2007,35(7):99-101. 被引量:6
  • 4Chen Zhuanke, Witter G. Electrical contacts for automotive applications: a review[J]. IEICE Transactions on Electronics, 2004, E87-C(8) : 1 248-1 254.
  • 5Li Zhenbiao,Wei Meifang, Hasegawa M. Effect of arcing behavior characteristics on welding resistance of relay contacts[J]. IEICE Trans on Electronics, 2007, E90-C(7): 1 385-1 390.
  • 6Doublet L, Jemaa N B. Make arc erosion and welding tendency under 42 V DC in automotive area[C]//Proceedings of the 49th IEEE Holm Conference on Electrical Contacts. Washington DC:IEEE, 2003: 158- 162.
  • 7Jemaa N B. Make arc parameters and subsequent erosion under 42V in automotive area[C]//Proceedings of the 48th IEEE Holm Conference on Electrical Contacts. Orlando: IEEE, 2002: 128-132.
  • 8Tomoya I. Growth of transferred pip and electrical properties of AgCdO make only contact in resistive circuit with DC14 and 42 V power supply[J]. IEICE Trans on Electronics, 2005, E88-C(8) : 1 670-1 674.
  • 9Nakayama T. Relationship between growth of transferred pip and arc duration at electrical contacts mounted on relays[J]. IEICE Transactions on Electronics, 2003, E86-C(6): 939-944.
  • 10Neuhaus, Alexander R. Influence of arc duration and current on contact welding in low power switches[C]//Proceedings of the Annual Holm Conference on Electrical Contacts. Orlando: IEEE, 2002:17-20.

共引文献10

同被引文献67

引证文献9

二级引证文献32

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部