期刊文献+

基于点应力破坏准则的含圆孔树脂基正交各向异性板的强度计算

Strength Calculation of Resin Matrix Orthotropic Plate with Round Hole Using Point Stress Failure Criterion
下载PDF
导出
摘要 对于实际工程中常见的含孔结构,建立利用保角映射原理对含圆孔树脂基复合材料板的孔边应力进行准确分析的方法,采用所给出的方法可以得到孔边在板边外荷载作用下的应力分布,然后采用点应力破坏准则对板进行全面的强度校核。文中不仅对带有圆形孔的复合材料板,在拉应力作用情况下的孔边应力场进行了计算,而且对外荷载、孔口尺寸、某点距孔边的距离以及材料性质等因素对应力的影响进行了较为全面的仿真分析。 To the common structure with hole in practical engineering,the accurate analytical method to study hole-edge stress of resin matrix composite plate with hole was developed upon the conformal mapping theory. According to this method,the hole-edge stress distribution subject to the exterior load at the plate edge can be obtained. And the point stress failure criterion was used to carry out the complete strength check of the plate. The calculation results show that in this paper,besides hole-edge stress of the composite plate with round hole subject to tensile stress,the influence which exterior load,hole size,distance away from hole edge and material property were all analyzed.
出处 《高分子材料科学与工程》 EI CAS CSCD 北大核心 2010年第10期163-166,共4页 Polymer Materials Science & Engineering
基金 国家自然科学基金资助项目(50975261) 教育部科学技术研究重点项目(208082) 教育部留学回国人员科研启动基金资助项目(200724)
关键词 含孔复合材料结构 点应力破坏准则 强度 应力场 composite structure with hole point stress failure criterion strength stress field
  • 相关文献

参考文献6

  • 1SAHA M, PRABHAKARAN R, WATERS W A. Compressive behavior of puhruded composite plates with circular holes [J ]. Composite Structures, 2004, 65 (1) : 29-36.
  • 2李成,郑艳萍.不同孔口形状对含孔复合材料板孔边应力状态影响的研究[J].工程力学,2007,24(10):19-24. 被引量:13
  • 3ALLAM M N M, ZENKOUR A M, EL-MEKAWY H F. Stress concentrations in a viscoelastic composite plate weakened by a triangular hole[J]. Composite Structures, 2007, 79(1): 1-11.
  • 4OZBAY M, OZER D. The analysis of elasto-plastie stresses in the composite laminate with a circular hole subjected to in-plane loads by means of finite element method[J ]. Journal of Reinforced Plastics and Composites, 2005, 24(6): 621-631.
  • 5YEN W J , HWU C. Green's functions of two-dimensional anisotropic plates containing an elliptic hole[J ]. International Journal of Solids and Structures, 1991, 27 (13) : 1705-1719.
  • 6LI C. Calculation of the stress along hole boundary in the composite platewith any type of holes [M]. Duesseldorf: the Association of German Engineers Publishing House, 2003.

二级参考文献13

  • 1Hufenbach W,Kroll L.Kerbspannungsanalyse anisotrop faserverstarkter scheiben[J].Archive of Applied Mechanics,1992,62:277-290.
  • 2Neuber H.Kerbspannungslehre.3.Aufl[M].Berlin,Heidelberg,New York,Tokyo:Springer Verlag,1985.
  • 3Muβchelischwili N L.Einige grundaufgaben zur mathematischen elastizit?tstheorie[M].Müchen:Carl Hanser Verlag,1971.
  • 4Lekhnitskii S G.Anisotropic plates[M].New York:Gorden and Breach,1968.
  • 5Engels H,Zakharov D,Becker W.The plane problem of an elliptically reinforced circular hole in an anisotropic plate or laminate[J].Archive of Applied Mechanics,2001,71(9):601-612.
  • 6Lin Chien-Chang,Lin Chuen-Horng.Stresses around pin-loaded hole in composite laminates using direct boundary element method[J].International Journal of Solids and Structures,1999,36(5):763-783.
  • 7Ozbay Mammut,Ozer Dllek.The analysis of elasto-plastic stresses in the composite laminate with a circular hole subjected to in-plane loads by means of finite element method[J].Journal of Reinforced Plastics and Composites,2005,24(6):621-631.
  • 8Hufenbach W,Schafer M,Herrmann A S.Berechnung des spannungsund verschiebungsfeldes anisotroper scheiben mit elliptischem ausschnitt[J].Ingenieur-Archiv,1990,60(8):507-517.
  • 9Theocaris P S.Peculiarities of the artifical crack[J].Engineering Fracture Mechanics,1991,38(1):37-54.
  • 10Radaj D.Kerbspannungen an Offnungen und starren Kernen[M].Düseldorf:Deutscher Verlag für Schweiβtechnik GmbH,1970.

共引文献12

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部