摘要
单一镀层难以满足实际要求,复合镀层则可以在较苛刻的条件下服役。在化学镀Ni-P合金镀液中添加聚偏氟二乙烯(PVDF)粒子制得了Ni-P/PVDF复合镀层,研究了复合镀层的形貌,并探讨了PVDF的添加量对镀层耐腐蚀性能的影响。结果表明:基础镀液中加入PVDF粒子后,获得的Ni-P/PVDF复合镀层表面均匀、致密,耐蚀性优于基材和Ni-P合金镀层;随着PVDF添加量的增加,Ni-P/PVDF复合镀层的耐蚀性先增强后减弱,当PVDF的添加量为3.0g/L时,复合镀层的耐蚀性最好。
Electroless Ni-P/polyvinylidene fluoride (PVDF) composite coating was prepared by introducing PVDF particulates into the plating bath of electroless Ni-P alloy coating. The morphology of resultant Ni-P/PVDF composite coating was observed, and the effect of PVDF content on the corrosion resistance of the composite coating was investigated. Results indicate that electroless Ni-P/PVDF composite coating obtained from the electroless Ni-P bath containing PVDF particulates is uniform and dense, and possesses better corrosion resistance than substrate and Ni-P alloy coating. The corrosion resistance of the coatings increased with increasing content of PVDF in the plating bath but decreased at a certain content of PVDF. The composite coating prepared from the plating bath containing 3.0 g/L PVDF had the best corrosion resistance.
出处
《材料保护》
CAS
CSCD
北大核心
2010年第11期62-63,69,共3页
Materials Protection
基金
山东省自然科学基金(Q2008F12)
中国石油大学(华东)博士基金(Y060314)
关键词
化学镀
Ni-P/PVDF镀层
形貌
耐蚀性
electroless plating
Ni-P/PVDF composite coating
morphology
corrosion resistance